This enables the below configuration so the AP and EC are able to
communicate over eSPI:
CONFIG_ESPI_PERIPHERAL_EC_HOST_CMD
CONFIG_ESPI_PERIPHERAL_ACPI_SHM_REGION
CONFIG_ESPI_PERIPHERAL_CUSTOM_OPCODE
Signed-off-by: Dino Li <Dino.Li@ite.com.tw>
BBRAM content should be cleared when boot from cutoff. Compare magic
number to decide whether to clear entire BBRAM.
Signed-off-by: Tim Lin <tim2.lin@ite.corp-partner.google.com>
The default I2C channel 3 is used by alternate function of GPIO H1/H2
Krabby uses GPIO F2/F3 as I2C channel 3, so we need to add the
compatibility of the GPIO F2/F3.
TEST=test on it8xxx2_evb:
zmake configure -b zephyr/projects/it8xxx2_evb/
Signed-off-by: Tim Lin <tim2.lin@ite.corp-partner.google.com>
The free run timer will be used to count before entering hibernate
mode. Move the related registers to the head file for accessing.
Signed-off-by: Tim Lin <tim2.lin@ite.corp-partner.google.com>
The delay will ensure last byte has been latched in before
This also change the method of reading status register from re-send
read status command on each read to read status register continuously.
Signed-off-by: Dino Li <Dino.Li@ite.com.tw>
Add flash driver for it8xxx2. The driver can implement
flash read, write and erase that will be mapped to the
ram section for executing.
TEST="flash write 0x80000 0x10 0x20 0x30 0x40 ..."
"flash read 0x80000 0x100"
"flash erase 0x80000 0x1000"
Signed-off-by: Tim Lin <tim2.lin@ite.corp-partner.google.com>
This commit fixes the ADC driver flow. And add internal
reference voltage to ADC driver API. And correct the
data buffer that only need to store raw data.
Signed-off-by: Tim Lin <tim2.lin@ite.corp-partner.google.com>
Add register address including external timer and watchdog(ETWD),
general control(GCTRL), serial peripheral interface(SPI).
Signed-off-by: Tim Lin <tim2.lin@ite.corp-partner.google.com>
This change enables A, C, D, E, G, H, I, J, K, and L groups,
and fix gpio interrupt function.
This change also pull (and rename) dt-bindings/irq.h to
dt-bindings/interrupt-controller/ite-intc.h, because it is
chip-specific.
Signed-off-by: Dino Li <Dino.Li@ite.com.tw>
Change-Id: Ifee039981c2cc4cf5980e663702a9921e629fc1e
This commit is about the it8xxx2 analog to digital converter
driver. Support 8 channels ch0~ch7 and 10-bit resolution.
Signed-off-by: Tim Lin <tim2.lin@ite.corp-partner.google.com>
This commit is about the it8xxx2 i2c master driver which
includes six SMBus channels. The enhanced channel i2c3,
i2c4, i2c5 are controller which are designed to support
the I2C protocol.
Signed-off-by: Tim Lin <tim2.lin@ite.corp-partner.google.com>
