The iMX RT bootrom allows the user to load images into RAM regions from
flash by providing a correctly configured boot header. In particular, if
the boot header contains a load address within RAM, the bootroom will
automatically copy the image to the load address before executing it
Introduce CONFIG_NXP_IMX_RT_ROM_RAMLOADER to enable this feature. This
Kconfig will shift the LMA of a image built to run in a RAM region to
reside in the default FlexSPI boot region, which allows the image to be
loaded to the FlexSPI region using west. This is intended to simplify
development of applications executing from RAM on iMX RT based systems.
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
Use CMSIS SystemInit for all NXP iMX.RT SOCs, to simplify initialization
flow, and remove redundant code where possible.
Introduce Kconfigs to disable Cache at boot, since SystemInit will enable
code cache on these platforms, which may be undesirable behavior.
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
Convert NXP LPC SOCs to use CMSIS SystemInit, and remove redundant code
where it exists. This will enable initialization flows to be more
standardized across all platforms.
Since LPC54xxx and LPC55xxx series enables SRAM banks in SystemInit,
provide Kconfigs to bypass this setting and keep additional SRAM
banks unclocked.
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
1. Add USB_STACK_USE_DEDICATED_RAM=1 define that is
used by the SDK USB driver
2. Delete unused "config USB_DEDICATED_MEMORY"
Signed-off-by: Mahesh Mahadevan <mahesh.mahadevan@nxp.com>
1. Update soc.c file to add USB clock setup
2. Add a linker file to move USB transfer
buffer and controller buffers to USB RAM
3. Update Kconfig's to add USB support
4. Add zephyr_udc0 nodelabel
Signed-off-by: Mahesh Mahadevan <mahesh.mahadevan@nxp.com>
- The MX25UM51345G flash is connected to FLEXSPI PortA for
mimxrt595_evk.
- Updated flexspi_mx25um51345g driver to support DTR OPI mode.
- Tested with tests/drivers/flash.
Signed-off-by: Chay Guo <changyi.guo@nxp.com>
According to Kconfig guidelines, boolean prompts must not start with
"Enable...". The following command has been used to automate the changes
in this patch:
sed -i "s/bool \"[Ee]nables\? \(\w\)/bool \"\U\1/g" **/Kconfig*
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
