Peter Bigot 9dc7640ede spi-device: set CS gpio flags for all devices that had none ... The generic SPI GPIO chip select support now respects devicetree flags for signal active level. Update all cs-gpios properties to specify active low. Signed-off-by: Peter Bigot <peter.bigot@nordicsemi.no>		2020-07-09 06:07:07 -05:00
..
doc	boards: efr32mg_sltb004a: Add support for sensor ccs811	2020-07-08 15:31:03 -05:00
board.c	boards: efr32mg_sltb004a: Add support for sensor ccs811	2020-07-08 15:31:03 -05:00
board.cmake	boards: efr32mg_sltb004a: Fix device name typos	2019-01-18 18:26:01 -05:00
board.h	boards: efr32mg_sltb004a: Add support for sensor ccs811	2020-07-08 15:31:03 -05:00
CMakeLists.txt	boards: efr32mg_sltb004a: Add support for sensor ccs811	2020-07-08 15:31:03 -05:00
efr32mg_sltb004a.dts	spi-device: set CS gpio flags for all devices that had none	2020-07-09 06:07:07 -05:00
efr32mg_sltb004a.yaml	boards: efr32mg_sltb004a: Enable watchdog	2020-02-03 11:25:40 -08:00
efr32mg_sltb004a_defconfig	kconfig: Remove assignments to CONFIG_<arch> syms and hide them	2020-02-08 00:50:08 -06:00
Kconfig	kconfig: Replace non-defconfig single-symbol 'if's with 'depends on'	2020-02-12 10:32:34 -06:00
Kconfig.board	kconfig: Clean up header comments and make them consistent	2019-11-04 17:31:27 -05:00
Kconfig.defconfig	drivers: gpio_gecko: convert to DT_INST defines	2020-03-24 10:14:21 -05:00