Erwan Gouriou 219a1e7f0b stm32f4: Update flash to support higher sysclock frequencies ... stm32f411re SoC could run at system clock above 84MHz. This was not taken into account in __setup_flash function which configure flash latency depending on system clock. This is now corrected. Assert added to ease error detection. Change-Id: I49b92256d611ef464171fb1d8812a4c4d3c27ab8 Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>		2017-01-12 09:46:25 -06:00
..
flash_registers.h	stm32f4: Update flash to support higher sysclock frequencies	2017-01-12 09:46:25 -06:00
gpio_registers.h	gpio: stm32: add support for STM32F4	2016-10-28 18:58:03 +00:00
Kconfig.defconfig.series	serial: Provide new numbering scheme for stm32 UART	2016-12-06 09:50:11 -06:00
Kconfig.defconfig.stm32f401xe	stm32f4: Adapt CONFIG_SOC to STM32Cube values	2016-11-03 20:29:06 +00:00
Kconfig.defconfig.stm32f411xe	board: add initial support for Nucleo-64 with Soc STM32F411RE	2016-12-20 09:15:19 -06:00
Kconfig.series	arm: systick: Some SoCs do not have systick	2016-11-27 19:39:26 +00:00
Kconfig.soc	board: add initial support for Nucleo-64 with Soc STM32F411RE	2016-12-20 09:15:19 -06:00
linker.ld	arm: st_stm32: Add support for STM32F4x SoC family	2016-10-28 18:58:02 +00:00
Makefile	pinmux: stm32: add support for STM32F4	2016-10-28 18:58:04 +00:00
rcc_registers.h	clock_control: stm32f4x: introduce driver for STM32F4x RCC	2016-10-28 18:58:03 +00:00
soc.c	kernel: replace all remaining nanokernel occurances	2016-12-25 14:34:43 -05:00
soc.h	stm32f4: Update after serial driver rework	2016-12-06 09:50:11 -06:00
soc_gpio.c	gpio: stm32: add support for STM32F4	2016-10-28 18:58:03 +00:00
soc_irq.h	arm: st_stm32: Add support for STM32F4x SoC family	2016-10-28 18:58:02 +00:00
soc_pinmux.c	soc: stm32xx: add pwm pinmux support	2016-12-06 10:31:46 -06:00
soc_registers.h	gpio: stm32: add support for STM32F4	2016-10-28 18:58:03 +00:00