Alexandre Bourdiol 6f55614222 board: arm: Enable MPU for all STM32 boards supporting it ... Only boards with at least 64K Flash will activate MPU because: MPU + UERSPACE + All switches implicity activated (CONFIG_MPU_STACK_GUARD, CONFIG_ARM_STACK_PROTECTION ...) will consume about 40K Flash (value computed on nucleo_f767_zi on tests/arch/arm/arm_ramfunc/). Signed-off-by: Alexandre Bourdiol <alexandre.bourdiol@st.com>		2020-06-19 08:55:44 -05:00
..
doc	boards: shrink image sizes	2020-02-07 13:52:45 -05:00
support	boards: arm: stm32: Fix openocd warning	2019-01-03 10:24:49 -06:00
arduino_r3_connector.dtsi	devicetree: tree-wide: add nexus map properties for arduino headers	2019-10-22 14:40:41 -05:00
board.cmake	boards: arm: st, stm32: add jlink runner args	2019-04-19 13:56:28 -05:00
CMakeLists.txt	boards: Set pinmux.c compilation under switch CONFIG_PINMUX	2019-06-10 12:42:49 +02:00
Kconfig.board	kconfig: Clean up header comments and make them consistent	2019-11-04 17:31:27 -05:00
Kconfig.defconfig	boards: stm32: Use dt API for serial peripheral configuration	2020-04-20 15:27:56 -05:00
nucleo_l053r8.dts	drivers/gpio: stm32: Remove Kconfig based device declaration	2020-04-02 06:50:05 -05:00
nucleo_l053r8.yaml	boards: stm32: Fix boards names in yaml and/or doc files	2020-05-05 10:05:56 -05:00
nucleo_l053r8_defconfig	board: arm: Enable MPU for all STM32 boards supporting it	2020-06-19 08:55:44 -05:00
pinmux.c	boards: stm32: pinmux: Restore Kconfig control on pinmux (i2c)	2020-05-20 12:09:19 +02:00