Erwan Gouriou c062cd260a drivers/ethernet: stm32: Enable Kconfig symbol ETH_STM32_HAL using dts ... It should not be needed to configure ETH_STM32_HAL from boards. Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>		2020-07-24 12:03:33 +02:00
..
doc	boards: shrink image sizes	2020-02-07 13:52:45 -05:00
support	boards: nucleo_f207zg: Enable automatic flashing	2020-01-16 07:52:12 -06:00
arduino_r3_connector.dtsi	devicetree: tree-wide: add nexus map properties for arduino headers	2019-10-22 14:40:41 -05:00
board.cmake	boards: arm: st, stm32: add jlink runner args	2019-04-19 13:56:28 -05:00
CMakeLists.txt	board: use ${ZEPHYR_BASE} instead of ${PROJECT_SOURCE_DIR}	2019-06-10 12:42:49 +02:00
Kconfig.board	kconfig: Clean up header comments and make them consistent	2019-11-04 17:31:27 -05:00
Kconfig.defconfig	drivers/ethernet: stm32: Enable Kconfig symbol ETH_STM32_HAL using dts	2020-07-24 12:03:33 +02:00
nucleo_f207zg.dts	boards: stm32: Enable ethernet devices through device tree	2020-07-24 12:03:33 +02:00
nucleo_f207zg.yaml	boards: arm: stm32f207 add rtc feature on the nucleo board	2020-06-10 09:40:21 +02:00
nucleo_f207zg_defconfig	board: arm: Enable MPU for all STM32 boards supporting it	2020-06-19 08:55:44 -05:00
pinmux.c	boards: stm32: Enable ethernet devices through device tree	2020-07-24 12:03:33 +02:00