Peter Bigot 9dc7640ede spi-device: set CS gpio flags for all devices that had none ... The generic SPI GPIO chip select support now respects devicetree flags for signal active level. Update all cs-gpios properties to specify active low. Signed-off-by: Peter Bigot <peter.bigot@nordicsemi.no>		2020-07-09 06:07:07 -05:00
..
doc	boards: shrink image sizes	2020-02-07 13:52:45 -05:00
96b_lscon.dtsi	boards: arm: 96b_wistrio: Add 3.3v Low speed connector support	2019-10-30 08:31:46 +01:00
96b_wistrio.dts	spi-device: set CS gpio flags for all devices that had none	2020-07-09 06:07:07 -05:00
96b_wistrio.yaml	doc: arm: 96b_wistrio: add EEPROM support to the boards doc	2019-12-12 07:57:33 -06:00
96b_wistrio_defconfig	board: arm: Enable MPU for all STM32 boards supporting it	2020-06-19 08:55:44 -05:00
board.cmake	boards: arm: 96b_wistrio: Use stm32flash runner	2020-01-13 12:25:12 +01:00
CMakeLists.txt	boards: Set pinmux.c compilation under switch CONFIG_PINMUX	2019-06-10 12:42:49 +02:00
Kconfig.board	kconfig: Clean up header comments and make them consistent	2019-11-04 17:31:27 -05:00
Kconfig.defconfig	boards: stm32: Use dt API for serial peripheral configuration	2020-04-20 15:27:56 -05:00
pinmux.c	boards: stm32: pinmux: Restore Kconfig control on pinmux (i2c)	2020-05-20 12:09:19 +02:00