Refactors all of the on-chip GPIO drivers to use a shared driver class
initialization priority configuration, CONFIG_GPIO_INIT_PRIORITY, to
allow configuring GPIO drivers separately from other devices. This is
similar to other driver classes like I2C and SPI.
Most drivers previously used CONFIG_KERNEL_INIT_PRIORITY_DEFAULT or
CONFIG_KERNEL_INIT_PRIORITY_DEVICE, therefore the default for this new
option is the lower of the two, which means earlier initialization.
Driver-specific options for off-chip I2C- or SPI-based GPIO drivers are
left intact because they often need to be initialized at a different
priority than on-chip GPIO drivers.
Signed-off-by: Maureen Helm <maureen.helm@intel.com>
GPIO L/K groups:
On IT81202 (128-pins package), the pins of GPIO group K and L aren't
bonding with pad. So we configure these pins as internal pull-down
at default to prevent leakage current due to floating.
GPIOH7:
On IT81202/IT81302, the GPIOH7 isn't bonding with pad and is left
floating internally. We need to enable internal pull-down for the pin
to prevent leakage current, but IT81202/IT81302 doesn't have the
capability to pull it down. We can only set it as output low,
so we enable output low for it at initialization to prevent leakage.
After setting: power saving=2.26mA
Signed-off-by: Tim Lin <tim2.lin@ite.corp-partner.google.com>
Fixed the following assertion causing by high level functions
enable gpio interrupt at the same pin at least two times:
ASSERTION FAIL [!arch_irq_is_enabled(irq)]
@ ZEPHYR_BASE/arch/common/sw_isr_common.c:84 IRQ xxx is enabled
Signed-off-by: Dino Li <Dino.Li@ite.com.tw>
This change enables A, C, D, E, G, H, I, J, K, and L groups,
and fix gpio interrupt function.
This change also pull (and rename) dt-bindings/irq.h to
dt-bindings/interrupt-controller/ite-intc.h, because it is
chip-specific.
Signed-off-by: Dino Li <Dino.Li@ite.com.tw>
Change-Id: Ifee039981c2cc4cf5980e663702a9921e629fc1e
Retain the assumption that the loop will assign a pointer, but
initialize it pointer first to eliminate build warnings.
Signed-off-by: Peter Bigot <peter.bigot@nordicsemi.no>
This commit is about platform it8xxx2 gpio.
The devicetree use key and led as example.
Users can change it to meet their needs.
Signed-off-by: Cheryl Su <Cheryl.su@ite.com.tw>
