49 lines
2.4 KiB
Markdown
49 lines
2.4 KiB
Markdown
# Board - Paris Air Hero 32 / Acro Naze 32 Mini
|
|
|
|
This board uses the same firmware as the Naze32 board.
|
|
|
|
## Sensors
|
|
|
|
MPU6500 via SPI interface.
|
|
|
|
## Ports
|
|
|
|
6 x 3pin ESC / Servo outputs
|
|
1 x 8pin JST connector (PPM/PWM/UART2)
|
|
1 x 4pin JST connector (UART3/I2C)
|
|
|
|
## Pinouts
|
|
|
|
The 10 pin RC I/O connector has the following pinouts when used in RX_PPM/RX_SERIAL mode.
|
|
|
|
From right to left when looking at the socket from the edge of the board.
|
|
|
|
| Pin | Function | Notes |
|
|
| --- | -------------- | -------------------------------- |
|
|
| 1 | Ground | |
|
|
| 2 | +5V | |
|
|
| 3 | RX_PPM | Enable `feature RX_PPM` |
|
|
| 4 | RSSI_ADC | Enable `feature RSSI_ADC`. Connect to the output of a PWM-RSSI conditioner, 0v-3.3v input |
|
|
| 5 | USART2 TX | |
|
|
| 6 | USART2 RX | Built-in inverter |
|
|
| 7 | LED_STRIP | Enable `feature LED_STRIP` |
|
|
| 8 | unused | |
|
|
|
|
When SOFTSERIAL is enabled, LED_STRIP and CURRENT_METER are unavailable, but one SoftSerial port is made available to use instead.
|
|
|
|
| Pin | Function | Notes |
|
|
| --- | -------------- | -------------------------------- |
|
|
| 7 | SOFTSERIAL1 RX | Enable `feature SOFTSERIAL` |
|
|
| 8 | SOFTSERIAL1 TX | |
|
|
|
|
|
|
## Serial Ports
|
|
|
|
| Value | Identifier | RX | TX | Notes |
|
|
| ----- | ------------ | ---------- | ------------------ | ------------------------------------------------------------------------------------------- |
|
|
| 1 | USART1 | RX / PA10 | TX / PA9 / TELEM | TELEM output is always inverted (for FrSky). Internally connected to USB port via CP2102 IC |
|
|
| 2 | USART2 | RC4 / PA3 | RC3 / PA2 | |
|
|
| 3 | USART3 | F3 / PB11 | F2 / PB10 | Flex port is configured as UART3 when port is configured |
|
|
| 4 | SOFTSERIAL1 | RC5 / PA6 | RC6 / PA7 | |
|
|
|