dongie
f83133fa74
Fixing missing reply in MSP_SET_MOTORS. Found by cTn
2014-02-20 19:56:40 +09:00
dongie
d40e8c0ef4
shows how many people use gimbal outputs.
...
regular gimbal rates has been broken since forever, same rate was applied to pitch and roll, instead of separate. thanx nicodh
2014-02-20 16:21:44 +09:00
dongie
96dcfe9174
Added support for fast sbus2 protocol (used by newer receivers). Untested, thanks Cesco
2014-02-19 16:36:10 +09:00
dongie
af13325f9e
building hex file for servo center fix
2014-02-18 15:42:13 +09:00
dongie
75ae09454b
Merge pull request #44 from DTFUHF/master
...
Have servos output midrc at startup
2014-02-18 15:40:43 +09:00
dongie
30afff2578
got rid of feature_gyro_smoothing. nobody used that, and its retarded to do anyway.
2014-02-18 15:27:53 +09:00
dongie
202fc17608
added max_angle_inclination to CLI to configure (default) 50 degree max inclination. configurable between 10 and 90 (100..900 in cli)
2014-02-18 15:23:02 +09:00
dongie
9d421b4a67
removed rc averaging for serialrx sources - suggested by cesco
2014-02-18 12:12:08 +09:00
DTF UHF
ac94147589
Have servos output midrc at startup instead of 1ms pulse (full deflection)
2014-02-14 15:15:38 -05:00
dongie
4e44cf62a2
Merge pull request #43 from kh4/master
...
Fix line endings to CRLF
2014-02-07 21:12:12 +09:00
kh4
ceb1f78526
Fix line endings to CRLF
2014-02-07 13:40:27 +02:00
dongie
0c46bdbfc8
added cli settings for pidvel
...
added (unsupported) GPS nav MSP numbers.
2014-02-04 08:21:40 +09:00
dongie
efedff771e
adding updated uvision project
2014-01-31 21:51:10 +09:00
dongie
e8b3d00003
implement (not flight tested) brushed motors support.
...
set motor_pwm_rate to some value > 500 (1000, 8000, 16000 etc works on my scope).
then the motor output can be used to directly drive brushed motor fets.
PWM is rescaled to 0-base in brushed mode, so all same values of min/maxthrottle apply.
2014-01-31 11:56:55 +09:00
dongie
a695ddd66a
added sumd serial receiver support by cesco/Plüschi
2014-01-31 10:02:50 +09:00
dongie
92c0947d7f
bump config version after PID default changes and add built hex file
2014-01-28 10:03:30 +09:00
dongie
e787a493dd
Merge pull request #42 from luggi/betteralthold
...
new althold PID
2014-01-27 16:34:13 -08:00
Lukas S
073f5116bb
new althold PID
...
althold should work better now, the PID settings are preliminary. There
is definetly room for improvement.
For aquiring your own PID settings set ALT_P = 0 and tune the VEL pid
until the copter only drifts a little from its position when you
activate althold. Then set ALT_P to a value where it holds the position
stable
2014-01-28 01:26:58 +01:00
dongie
cae8682c62
Merge pull request #41 from schugabe/master
...
modified MSP implementation to reflect MW2.3 changes
2014-01-27 05:38:39 -08:00
Johannes Kasberger
142bb20ae6
modified MSP implementation to reflect MW2.3 changes
2014-01-27 14:27:43 +01:00
dongie
e4746e60cf
hex to match latest source commits
2014-01-26 09:32:12 +09:00
Dominic Clifton
398fcffd1a
Merge remote-tracking branch 'multiwii/master'
2014-01-24 18:45:38 +00:00
dongie
cc2a6f502e
Merge pull request #38 from DTFUHF/master
...
Enable gimbal_flags servo passthrough in airplane mode and other mixer modes that use servos
2014-01-23 15:41:12 -08:00
DTF UHF
1cb905b7c2
fix spacing
2014-01-23 17:52:04 -05:00
DTF UHF
d0a5a66b62
Enable gimbal_flags servo passthru in airplane modes and other mixer modes that use servos
2014-01-23 17:48:27 -05:00
dongie
a2c9ea3e8b
Merge pull request #34 from KipK/Telemetry_switch
...
Telemetry switch
2014-01-17 14:57:13 -08:00
KipK
6ee98fed90
indents
2014-01-17 17:02:48 +01:00
KipK
e198f1727b
telemetry_switch: fixed condition when using softserial
2014-01-17 11:07:59 +01:00
KipK
7bd2db04be
Added a mcfg.telemetry_switch for CLI
...
If telemetry_switch=1 it change baudrate and protocol using aux channel, either it switch when armed/disarmed.
This allows to keep MSP serial while armed for BT dongle if needed.
2014-01-16 19:36:54 +01:00
KipK
0d974e2882
reverting previous fix. This doesn't solve all conditions.
...
I need to add a telemetry_switch conf or feature to solve enabling MSP over FRSKy with switch not activated when armed ( i.e. using bt serial for tuning sessions ), but it will break when not using telemetry switch.
Better to keep it like this for now.
2014-01-16 17:18:43 +01:00
dongie
c19f6d1355
Merge pull request #33 from KipK/Telemetry_switch
...
Telemetry switch: fix stupid mistake
2014-01-16 07:45:14 -08:00
KipK
b55496b13f
Telemetry switch: fix stupid mistake
2014-01-16 16:18:36 +01:00
dongie
94d1e19403
Merge pull request #32 from KipK/Telemetry_switch
...
Start Frsky telemetry using a switch without beeing armed.
2014-01-15 05:54:58 -08:00
KipK
e6889aea12
Start Frsky telemetry using a switch without beeing armed.
...
This adds a Telemetry checkbox in the gui.
2014-01-15 14:53:03 +01:00
dongie
8c4a594808
build for throttle angle correction
2014-01-15 22:06:31 +09:00
dongie
699dc00332
Merge branch 'fix' of https://github.com/treymarc/baseflight into treymarc-fix
2014-01-15 22:04:19 +09:00
dongie
a206965854
adding support for maxthrottle and mincommand in MSP_SET_MISC now that all the tools can use it.
2014-01-15 19:37:31 +09:00
dongie
9a7ff04422
adding untested (and needing work) fixedwing althold implementation.
...
see comments in code for things to fix. added new variable to cli, fixedwing_althold_dir (though its value isn't really clear, I think it should always be positive since servo direction mix is done later).
2014-01-06 21:38:36 +09:00
treymarc
b2e7c8d8fc
THROTTLE ANGLE CORRECTION , "*" "/" operator priority bug
...
http://www.multiwii.com/forum/viewtopic.php?f=8&t=4433
2014-01-04 22:19:51 +01:00
dongie
1dea496fd5
build for mixer update
2014-01-01 19:44:33 +09:00
dongie
edd2d4921b
Merge pull request #28 from treymarc/temp
...
correction for mixerHex6P and mixerHex6X
2014-01-01 02:41:56 -08:00
dongie
f29405ffb0
whitespace fixes in Makefile
2014-01-01 19:19:10 +09:00
treymarc
bf5b70f4e2
remove newlib stub , add mixer correction
2014-01-01 10:23:48 +01:00
treymarc
01f079c254
ed
2014-01-01 10:18:18 +01:00
treymarc
239120ba4e
ignore white space
2014-01-01 10:14:23 +01:00
treymarc
2caa1fbb20
add newlib stubs
2014-01-01 09:42:14 +01:00
treymarc
d885e39a90
type float
2014-01-01 09:24:12 +01:00
treymarc
c76a9669f6
mixer coorection for hexa6x and hexa6p
2014-01-01 09:17:13 +01:00
treymarc
033a8fbe3f
ident/format
2014-01-01 09:16:41 +01:00
dongie
13324c9f88
build binary for the previous GPS baud rate index fix
2013-12-27 08:37:17 +09:00
