Erwan Gouriou e26767fc06 drivers/gpio: stm32: Remove Kconfig based device declaration ... Use device node declaration instead. Clean up GPIO_STM32_PORT* Kconfig symbols. On some boards some gpio ports where disabled using Kconfig symbols. Disable them now via device tree nodes in boards dts files. Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>		2020-04-02 06:50:05 -05:00
..
doc	boards: shrink image sizes	2020-02-07 13:52:45 -05:00
support	boards: arm: provide support for nucleo f030r8.	2017-10-23 12:31:47 +02:00
arduino_r3_connector.dtsi	devicetree: tree-wide: add nexus map properties for arduino headers	2019-10-22 14:40:41 -05:00
board.cmake	boards: arm: st, stm32: add jlink runner args	2019-04-19 13:56:28 -05:00
CMakeLists.txt	boards: Set pinmux.c compilation under switch CONFIG_PINMUX	2019-06-10 12:42:49 +02:00
Kconfig.board	kconfig: Clean up header comments and make them consistent	2019-11-04 17:31:27 -05:00
Kconfig.defconfig	drivers/gpio: stm32: Remove Kconfig based device declaration	2020-04-02 06:50:05 -05:00
nucleo_f030r8.dts	drivers/gpio: stm32: Remove Kconfig based device declaration	2020-04-02 06:50:05 -05:00
nucleo_f030r8.yaml	boards: stm32: Set arduino gpio connector on nucleo 64 pins boards	2019-10-07 12:51:14 -05:00
nucleo_f030r8_defconfig	kconfig: Remove assignments to CONFIG_<arch> syms and hide them	2020-02-08 00:50:08 -06:00
pinmux.c	drivers: spi: spi_ll_stm32: Add config to manage slave select	2019-08-01 11:58:02 -04:00