Erwan Gouriou c062cd260a drivers/ethernet: stm32: Enable Kconfig symbol ETH_STM32_HAL using dts ... It should not be needed to configure ETH_STM32_HAL from boards. Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>		2020-07-24 12:03:33 +02:00
..
doc	boards: stm32f746g_disco: Update board doc for sdmmc	2020-05-08 10:53:10 +02:00
support	boards: arm: stm32: Basic support for STM32F746G-DISCO board	2018-06-28 08:29:32 -05:00
arduino_r3_connector.dtsi	boards: stm32: Extend stm32f746g_disco board with Arduino header	2020-06-26 12:04:19 -05:00
board.cmake	boards: arm: st, stm32: add jlink runner args	2019-04-19 13:56:28 -05:00
CMakeLists.txt	board: use ${ZEPHYR_BASE} instead of ${PROJECT_SOURCE_DIR}	2019-06-10 12:42:49 +02:00
Kconfig.board	kconfig: Clean up header comments and make them consistent	2019-11-04 17:31:27 -05:00
Kconfig.defconfig	drivers/ethernet: stm32: Enable Kconfig symbol ETH_STM32_HAL using dts	2020-07-24 12:03:33 +02:00
pinmux.c	boards: stm32: Enable ethernet devices through device tree	2020-07-24 12:03:33 +02:00
stm32f746g_disco.dts	boards: stm32: Enable ethernet devices through device tree	2020-07-24 12:03:33 +02:00
stm32f746g_disco.yaml	boards: arm: stm32f746g_disco: enable sdmmc support	2020-05-08 10:53:10 +02:00
stm32f746g_disco_defconfig	board: arm: Enable MPU for all STM32 boards supporting it	2020-06-19 08:55:44 -05:00