Erwan Gouriou 25dfbe3e7e boards: stm32: pinmux: Restore Kconfig control on pinmux (i2s) ... In order to avoid pin configuration conflicts between peripherals, add CONFIG_I2S flag to for each i2s pinmux configuration. Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>		2020-05-20 12:09:19 +02:00
..
doc	boards/nucleo_f411re: Enable I2S support	2020-05-06 10:33:07 -05:00
support	board: add initial support for Nucleo-64 with Soc STM32F411RE	2016-12-20 09:15:19 -06:00
arduino_r3_connector.dtsi	boards/nucleo_f411re: Enable I2S support	2020-05-06 10:33:07 -05:00
board.cmake	boards: arm: st, stm32: add jlink runner args	2019-04-19 13:56:28 -05:00
CMakeLists.txt	boards: Set pinmux.c compilation under switch CONFIG_PINMUX	2019-06-10 12:42:49 +02:00
Kconfig.board	kconfig: Clean up header comments and make them consistent	2019-11-04 17:31:27 -05:00
Kconfig.defconfig	boards: stm32: Use dt API for serial peripheral configuration	2020-04-20 15:27:56 -05:00
nucleo_f411re.dts	boards: stm32: Update board definition using new GPIO api	2020-02-05 12:00:36 +01:00
nucleo_f411re.yaml	boards/nucleo_f411re: Enable I2S support	2020-05-06 10:33:07 -05:00
nucleo_f411re_defconfig	kconfig: Remove assignments to CONFIG_<arch> syms and hide them	2020-02-08 00:50:08 -06:00
pinmux.c	boards: stm32: pinmux: Restore Kconfig control on pinmux (i2s)	2020-05-20 12:09:19 +02:00