zephyr/boards/arm/lpcxpresso55s69
David Brown 79daf21189 dts: arm: nxp: nxp_lpc55s6x: Use proper code partition
The zephyr,code-parition was set incorrectly to SRAM.  Set it to the
slot0 partition, so that enabling BOOTLOADER_MCUBOOT will place the code
at the proper address.

Signed-off-by: David Brown <david.brown@linaro.org>
2020-07-15 13:29:50 +02:00
..
doc boards: lpcxpresso55s69: Enable i2c instance 4 2020-04-09 08:52:13 -05:00
board.cmake boards: arm: Remove OPENSDA_FW cmake variables from nxp boards 2020-07-09 07:58:50 -05:00
CMakeLists.txt boards: lpcxpresso55s69 initalization 2019-06-03 15:49:35 -05:00
Kconfig.board kconfig: Clean up header comments and make them consistent 2019-11-04 17:31:27 -05:00
Kconfig.defconfig boards: Remove Kconfig I2C_[0-9] usage 2020-05-06 10:55:38 -05:00
lpcxpresso55s69.dtsi boards: lpcxpresso55s69 add Arduino mapping 2020-05-20 19:02:36 +02:00
lpcxpresso55s69_cpu0.dts dts: arm: nxp: nxp_lpc55s6x: Use proper code partition 2020-07-15 13:29:50 +02:00
lpcxpresso55s69_cpu0.yaml boards: lpcxpresso55s69: Enable i2c instance 4 2020-04-09 08:52:13 -05:00
lpcxpresso55s69_cpu0_defconfig boards: arm: lpcxpresso55s69: add missing CPU Kconfig settings 2020-05-01 10:11:01 -05:00
lpcxpresso55s69_cpu1.dts boards: lpcxpresso55s69_cpu1 definitions 2020-03-12 12:24:12 +02:00
lpcxpresso55s69_cpu1.yaml boards: lpcxpresso55s69_cpu1 definitions 2020-03-12 12:24:12 +02:00
lpcxpresso55s69_cpu1_defconfig boards: arm: lpcxpresso55s69: add missing CPU Kconfig settings 2020-05-01 10:11:01 -05:00
lpcxpresso55s69_ns.dts boards: remove usage of deprecated GPIO flags from .dts 2020-06-16 19:13:05 +02:00
lpcxpresso55s69_ns.yaml boards: arm: lpcxpresso55s69: Get non-secure config building 2020-04-17 10:16:40 -05:00
lpcxpresso55s69_ns_defconfig boards: arm: lpcxpresso55s69: add missing CPU Kconfig settings 2020-05-01 10:11:01 -05:00
pinmux.c boards: lpcxpresso55s69 use GPIO as SPI CS 2020-06-17 08:52:42 +03:00
pre_dt_board.cmake boards: suppress dtc simple_bus_reg warning on LPC 2020-02-05 13:04:44 -06:00