984bfae831
Remove leading/trailing blank lines in .c, .h, .py, .rst, .yml, and .yaml files. Will avoid failures with the new CI test in https://github.com/zephyrproject-rtos/ci-tools/pull/112, though it only checks changed files. Move the 'target-notes' target in boards/xtensa/odroid_go/doc/index.rst to get rid of the trailing blank line there. It was probably misplaced. Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no>
59 lines
1.9 KiB
ReStructuredText
59 lines
1.9 KiB
ReStructuredText
.. _decawave_dwm1001_dev:
|
|
|
|
Decawave DWM1001
|
|
#################
|
|
|
|
Overview
|
|
********
|
|
|
|
The DWM1001 development board includes the DWM1001 module, battery
|
|
connector and charging circuit, LEDs, buttons, Raspberry-Pi and USB
|
|
connector. In addition, the board comes with J-Link OB adding
|
|
debugging and Virtual COM Port capabilities.
|
|
|
|
See `Decawave DWM1001-DEV website`_ for more information about the development
|
|
board, `Decawave DWM1001 website`_ about the board itself, and `nRF52832 website`_ for the official reference on the IC itself.
|
|
|
|
Programming and Debugging
|
|
*************************
|
|
|
|
Applications for the ``decawave_dwm1001_dev`` board configuration can be
|
|
built and flashed in the usual way (see :ref:`build_an_application`
|
|
and :ref:`application_run` for more details); however, the standard
|
|
debugging targets are not currently available.
|
|
|
|
Flashing
|
|
========
|
|
|
|
Follow the instructions in the :ref:`nordic_segger` page to install
|
|
and configure all the necessary software. Further information can be
|
|
found in :ref:`nordic_segger_flashing`. Then build and flash
|
|
applications as usual (see :ref:`build_an_application` and
|
|
:ref:`application_run` for more details).
|
|
|
|
Here is an example for the :ref:`hello_world` application.
|
|
|
|
First, run your favorite terminal program to listen for output.
|
|
|
|
.. code-block:: console
|
|
|
|
$ minicom -D <tty_device> -b 115200
|
|
|
|
Replace :code:`<tty_device>` with the port where the board nRF52 DK
|
|
can be found. For example, under Linux, :code:`/dev/ttyACM0`.
|
|
|
|
Then build and flash the application in the usual way.
|
|
|
|
.. zephyr-app-commands::
|
|
:zephyr-app: samples/hello_world
|
|
:board: decawave_dwm1001_dev
|
|
:goals: build flash
|
|
|
|
References
|
|
**********
|
|
.. target-notes::
|
|
|
|
.. _nRF52832 website: https://www.nordicsemi.com/Products/Low-power-short-range-wireless/nRF52832
|
|
.. _Decawave DWM1001 website: https://www.decawave.com/product/dwm1001-module
|
|
.. _Decawave DWM1001-DEV website: https://www.decawave.com/product/dwm1001-development-board
|