eaffad0ced
The HTML documentation generation does not work properly if we try to put more than one board into same directory. So rename the directory to reflect this. Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
40 lines
851 B
Plaintext
40 lines
851 B
Plaintext
# SPDX-License-Identifier: Apache-2.0
|
|
|
|
CONFIG_SOC_SERIES_STM32F4X=y
|
|
CONFIG_SOC_STM32F407XE=y
|
|
# 168MHz system clock
|
|
CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC=168000000
|
|
|
|
# Enable MPU
|
|
CONFIG_ARM_MPU=y
|
|
|
|
# Enable UART
|
|
CONFIG_SERIAL=y
|
|
|
|
# Console
|
|
CONFIG_CONSOLE=y
|
|
CONFIG_UART_CONSOLE=y
|
|
|
|
# Enable pinmux
|
|
CONFIG_PINMUX=y
|
|
|
|
# Clock configuration
|
|
CONFIG_CLOCK_CONTROL=y
|
|
|
|
# Enable GPIO
|
|
CONFIG_GPIO=y
|
|
|
|
# Clock configuration for Cube Clock control driver
|
|
CONFIG_CLOCK_STM32_HSE_CLOCK=8000000
|
|
CONFIG_CLOCK_STM32_SYSCLK_SRC_PLL=y
|
|
# Use HSE as PLL input
|
|
CONFIG_CLOCK_STM32_PLL_SRC_HSE=y
|
|
# Produce 168MHz clock at PLL output
|
|
CONFIG_CLOCK_STM32_PLL_M_DIVISOR=8
|
|
CONFIG_CLOCK_STM32_PLL_N_MULTIPLIER=336
|
|
CONFIG_CLOCK_STM32_PLL_P_DIVISOR=2
|
|
CONFIG_CLOCK_STM32_PLL_Q_DIVISOR=7
|
|
CONFIG_CLOCK_STM32_AHB_PRESCALER=1
|
|
CONFIG_CLOCK_STM32_APB1_PRESCALER=4
|
|
CONFIG_CLOCK_STM32_APB2_PRESCALER=2
|