7e95006abf
Adds pinctrl driver for the v2m_beetle board target. Signed-off-by: Samuel Chee <samche01@arm.com> Signed-off-by: Sudan Landge <sudan.landge@arm.com>
44 lines
1.3 KiB
C
44 lines
1.3 KiB
C
/*
|
|
* Copyright 2025 Arm Limited and/or its affiliates <open-source-office@arm.com>
|
|
*
|
|
* SPDX-License-Identifier: Apache-2.0
|
|
*/
|
|
|
|
#include "zephyr/device.h"
|
|
#include "zephyr/drivers/gpio.h"
|
|
#include <zephyr/drivers/pinctrl.h>
|
|
#include <zephyr/devicetree/gpio.h>
|
|
#include <zephyr/drivers/gpio/gpio_cmsdk_ahb.h>
|
|
|
|
#define EXPANSION_SHIELD_POWER_ENABLE_MASK BIT(15)
|
|
|
|
static const struct device *const gpio_ports[] = {DEVICE_DT_GET_OR_NULL(DT_NODELABEL(gpio0)),
|
|
DEVICE_DT_GET_OR_NULL(DT_NODELABEL(gpio1))};
|
|
|
|
static int pinctrl_configure_pin(const pinctrl_soc_pin_t *pin)
|
|
{
|
|
uint32_t flags = pin->input_enable ? GPIO_INPUT : GPIO_OUTPUT;
|
|
|
|
/* Each gpio has 16 pins, so divide by 16 to get specific gpio*/
|
|
const struct device *gpio_dev = gpio_ports[pin->pin_num >> 4];
|
|
|
|
return cmsdk_ahb_gpio_config(gpio_dev, pin->pin_num % 16, flags);
|
|
}
|
|
|
|
int pinctrl_configure_pins(const pinctrl_soc_pin_t *pins, uint8_t pin_cnt, uintptr_t reg)
|
|
{
|
|
ARG_UNUSED(reg);
|
|
for (uint8_t i = 0U; i < pin_cnt; i++) {
|
|
if (pinctrl_configure_pin(pins++) == -ENOTSUP) {
|
|
return -ENOTSUP;
|
|
}
|
|
}
|
|
|
|
const struct gpio_cmsdk_ahb_cfg *const cfg = gpio_ports[1]->config;
|
|
/* Set the ARD_PWR_EN GPIO1[15] as an output */
|
|
cfg->port->outenableset |= EXPANSION_SHIELD_POWER_ENABLE_MASK;
|
|
/* Set on 3v3 (for ARDUINO HDR compliance) */
|
|
cfg->port->data |= EXPANSION_SHIELD_POWER_ENABLE_MASK;
|
|
|
|
return 0;
|
|
}
|