Simplify the implementation by using gpio_dt_spec. Mostly
gpio_dt_spec is used as a common struct and lets us move
away from DT_INST_GPIO_LABEL.
Signed-off-by: Kumar Gala <galak@kernel.org>
Move to use DEVICE_DT_GET instead of device_get_binding as we
work on phasing out use of DTS 'label' property.
Signed-off-by: Kumar Gala <galak@kernel.org>
The use of DT_BUS_LABEL in a logging call can easily be replaced
with uart_dev->name. This moves us slowly forward to removing
use of devicetree `label` property.
Signed-off-by: Kumar Gala <galak@kernel.org>
Move to use DEVICE_DT_GET_ONE instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Kumar Gala <galak@kernel.org>
Move to use DEVICE_DT_GET instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Kumar Gala <galak@kernel.org>
Move to use DEVICE_DT_GET instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Kumar Gala <galak@kernel.org>
This adds a new stm32f412Rx in the list of stm32F4 devices.
The module stm32cube/stm32f4/soc/stm32f412rx.h exists
Signed-off-by: Francois Ramu <francois.ramu@st.com>
Some stm32 devices, like stm32F4, do not have
a PLL Enable bit on the PLLP nor PLLQ divider
in their PLL config register (PLLCFGR).
The result is a empty function.
Signed-off-by: Francois Ramu <francois.ramu@st.com>
The function get_pllsrc_frequency is added
with possible source HSI or HSE.
With STM32_PLL_P_ENABLED or STM32_PLL_Q_ENABLED,
this function is used by the clock control driver.
Signed-off-by: Francois Ramu <francois.ramu@st.com>
The STM32_SRC_xxx definitions which are needed
for some peripherals of the stm32f4 soc.
Only the minimum clock sources are listed.
Signed-off-by: Francois Ramu <francois.ramu@st.com>
Move to pass 'struct device' instead of a 'char *'. This lets us move
from device_get_binding to DEVICE_DT_GET.
Signed-off-by: Kumar Gala <galak@kernel.org>
Move to use DEVICE_DT_GET instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Note: the CONFIG_COUNTER_CMOS driver is devicetree based so we can
remove the hardcoded "CMOS" and use DT_COMPAT_GET_ANY_STATUS_OKAY.
Signed-off-by: Kumar Gala <galak@kernel.org>
Move to pass 'struct device' instead of a 'char *'. This lets us move
from device_get_binding to DEVICE_DT_GET.
Signed-off-by: Kumar Gala <galak@kernel.org>
Change some behaviors when --log-only is passed in order to add support
for DSP power state: D3. This makes it possible to keep `cavstool
--log-only` running permanently in the "real-world" use case where the
Linux kernel loads the firmware and powers down audio when not in use.
More specifically:
- Do not disable D3 when using --log-only.
- Wait forever for the FW at boot time.
- Check live status when an invalid IPC is received and wait forever if
not alive.
Signed-off-by: Marc Herbert <marc.herbert@intel.com>
Add a new timeout_s parameter that can also be 'None' = infinite.
No functional change. Required to add future support for DSP power
state: D3
Signed-off-by: Marc Herbert <marc.herbert@intel.com>
Move to use DEVICE_DT_GET_ONE instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Kumar Gala <galak@kernel.org>
The TI SimpleLink SDK got updated to version '4.40.04.04' in 'hal_ti'.
This introduced renames of some functions in HAL and has to be reflected
in Zephyr drivers which make use of them.
This renames 'PRCMPowerDomainStatus' to 'PRCMPowerDomainsAllOn' in all
affected 'cc13xx_cc26xx' drivers.
Signed-off-by: Piotr Dymacz <pepe2k@gmail.com>
This update brings the following changes from 'hal_ti':
b00ac9b simplelink: cc13x2_cc26x2: include flash driverlib sources
bcc5286 zephyr: kconfig for CC13x2P / CC26x2P variants
c54f72e zephyr: kconfig for CC13x2 / CC26x2 custom RF HWAttrs
b6ca1ac cc13x2_cc26x2: update to TI SimpleLink SDK 4.40.04.04
The b00ac9b ("simplelink: cc13x2_cc26x2: include flash driverlib
sources") is required by recently introduced on-chip flash driver
for CC13xx/CC26xx series.
Fixes: #47461
Signed-off-by: Piotr Dymacz <pepe2k@gmail.com>
hifive_unmatched has a jedec,spi-nor flash node, however we have no
SPI driver for the controller so exclude the platform from this sample.
Signed-off-by: Kumar Gala <galak@kernel.org>
Move to use DEVICE_DT_GET instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Kumar Gala <galak@kernel.org>
Use the same function at discovery complete, whether discovery failed
or succeeded.
Rename the discovery_failure() to discovery_complete(), and use that
also when discovery completes successfully.
Signed-off-by: Asbjørn Sæbø <asbjorn.sabo@nordicsemi.no>
The media control client used to subscribe to GMCS characteristics as
the characteristics were discovered, in effect queuing ATT requests.
Since then, the ATT MTU exchange has become automatic, leading to
larger ATT MTUs and more discovered characteristics per ATT response,
which again lead to the client enqueuing more subscriptions and
running out of buffers, with discovery failing as a result.
This commit moves the subscription to GMCS characteristics to a
separate sequence, so that it happens serially after discovery, rather
than in parallel with the discovery.
- Remove separate discovery parameters for the characteristics - they
are no longer needed.
- Add a subscription callback and a couple of subscription functions
The subscription for characteristics for the included OTS has not been
modified. Only two of these are subscribed to, and doing that is
currently not a problem. And I need to better understand the
interaction with OTS and how these subscriptipons are used.
Signed-off-by: Asbjørn Sæbø <asbjorn.sabo@nordicsemi.no>
Refactor subscription to get chaining into callback
Move the start of discovery of included services to a separate
function, in preparation for rewriting discovery.
Signed-off-by: Asbjørn Sæbø <asbjorn.sabo@nordicsemi.no>
When bool is typedef'ed to for instance char the cast from 64 bits
is not so good. Now using an explicit 'cast' to true/false
Signed-off-by: Erik Brockhoff <erbr@oticon.com>
Implements PDU flow and unittest of CIS Create on Peripheral
Hooks CIS Create into the controller and fixes a few minor
things in ull to allow for running with NEW LLCP
Also handles CONFIG based comilation of CIS Create
Signed-off-by: Erik Brockhoff <erbr@oticon.com>
Hooks the CIS terminate into the controller and fixes a few minor
things in ull_conn(_iso).c
Also handles CONFIG based comilation of CIS_TERMINATE
also fixes a minor issue in helpers_pdu
Signed-off-by: Erik Brockhoff <erbr@oticon.com>
Every architecture must export the z_irq_spurious definition. Just unify
that in one single header file.
Signed-off-by: Carlo Caione <ccaione@baylibre.com>
Add macro Z_TEST_SKIP_IFNDEF which is used when you want to skip test
if configuration option is not enabled.
Signed-off-by: Andrei Emeltchenko <andrei.emeltchenko@intel.com>
The hwinfo shell commands was missing human readable names for
* RESET_HARDWARE
* RESET_USER
* RESET_TEMPERATURE
Signed-off-by: Pieter De Gendt <pieter.degendt@basalte.be>
