Add a prompt to the Kconfig symbol so that applications can select this in
to guide C++ standard library selection towards configurations which
provide a complete implementation.
Signed-off-by: Keith Packard <keithp@keithp.com>
Add configurations where CONFIG_BT_AUDIO_TX and CONFIG_BT_AUDIO_RX
are disabled.
Fixes issues found in the BT shell implemented caused by these
configurations.
Signed-off-by: Emil Gydesen <emil.gydesen@nordicsemi.no>
Move the BT_AUDIO_TX guard so that it does not cover the
verification functions for valid_codec and qos, as they
are also relevant for receivers to verify what remote
devices send.
Signed-off-by: Emil Gydesen <emil.gydesen@nordicsemi.no>
Set STM32CubeHAL ethernet version in use as V2 by default, on series
supporting it (H7, F7, F4). Not yet available on F2 series.
Add a choice symbol to explicit V1 version as deprecated.
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Add mcuboot DT aliases for LED and button. These can be used by MCUboot
when recovery mode entrance via GPIO is enabled.
Signed-off-by: Roman Dobrodii <rdobrodii@antmicro.com>
- To link image loadable by MCUboot, zephyr,code-partition
must be set in the DTS.
- Move partition definitions from SoC DTS to the board DTS.
- Remove scratch partition since MCUboot does not recommend to use it.
- Increase bootloader partitions to 48K to fit recent MCUboot.
Signed-off-by: Roman Dobrodii <rdobrodii@antmicro.com>
It is enabled by default if Device Tree includes a flash controller,
and disabled otherwise. SoC defconfig should not touch it.
Signed-off-by: Roman Dobrodii <rdobrodii@antmicro.com>
There is a chance that a previous declaration exists of socklen_t
through the unistd.h header. Luckily that header defines a macro
when it defines the type. This commit therefore uses that define to
know if the type has already been declared or not, similar to what
unistd.h does.
Closes#57195
Signed-off-by: Hein Wessels <heinwessels93@gmail.com>
The SAM GMAC driver is not utilizing the entire receive buffer, causing
large packets to be dropped. Fix it by setting Receiver Packet Buffer
Memory Size Select to Full (RXBMS = 3) in the GMAC_DCFGR register.
Fixes#55701
Signed-off-by: Brandon Del Bel <delbel@umn.edu>
Fix tcp_send_zwp() retransmission timeout calculation to avoid sign
extension on bit shift operation: the uint16_t value was implicitly
promoted to 32-bit signed type with sign extension to uint64_t.
Signed-off-by: Dmitrii Golovanov <dmitrii.golovanov@intel.com>
Some compilers and static analyzers warn when non-static (globals) are
not declared in some .h file. Tweak the generated code and add an
`extern` declaration before each device handle definition to make it
look it was declared in a (non-existent) .h file.
This makes the code a bit longer but it is already generated and very
repetitive anyway.
In the typical SOF configuration this silences about 150 sparse
warnings; as many as device handles.
Signed-off-by: Marc Herbert <marc.herbert@intel.com>
When building with arm-clang we get warnings of the type:
wncm14a2a.c:828:14: error: array subscript is of type
'char' [-Werror,-Wchar-subscripts]:
} else if (isalpha(c2) != 0) {
^~~~~~~~~~~
Fix this by adding explicit casts to (int) when callinng isalpha()
or isdigit().
Signed-off-by: Kumar Gala <kumar.gala@intel.com>
Add limits.h header that defines PATH_MAX as this is not defined
by the toolchain headers.
The value of 256 for PATH_MAX is based on how it is set in
lib/libc/minimal/include/limits.h.
Signed-off-by: Kumar Gala <kumar.gala@intel.com>
As the test uses iterable sections, we need to utilize
zephyr_iterable_section for targets that need linker script
generation like arm-clang.
So add zephyr_iterable_section() for the ROM sections that the
testcases utilizes.
Signed-off-by: Kumar Gala <kumar.gala@intel.com>
Modify defconfig logic for BG2x Thunderboard:
- Board's defconfig will enable CONFIG_REGULATOR only if
CONFIG_SI7210 is enabled.
- CONFIG_SI7210 is enabled if CONFIG_SENSOR is set by the app.
Signed-off-by: Roman Dobrodii <rdobrodii@antmicro.com>
The C language says that use of a NULL FILE pointer with stdio functions is
undefined behavior. Let's just remove them instead of expecting the minimal
C library to exhibit a specific behavior in this case.
This also avoids problems when not using -ffreestanding as in that case,
the C compiler may generate warnings, or even cause undefined behavior on
its own.
Signed-off-by: Keith Packard <keithp@keithp.com>
This ensures that the compiler won't end up recognizing patterns in code
that map to known built-in functions, like noticing that the memcpy
implementation looks a lot like a memory copy operation that could be
replaced by a call to ... memcpy.
When built with -ffreestanding, this has no effect as that option always
enables -fno-builtin.
Signed-off-by: Keith Packard <keithp@keithp.com>
When gcc is building without -fno-builtin, it will optimize calls like
printf("\n") into a call to putchar('\n'), but it won't use a static inline
in that case, instead insisting on a real function.
To make this a bit easier, adopt the usual C library practice of making
putc and putchar macros instead of static inline functions. There's no loss
of typechecking as the parameters are directly passed to underlying
functions with the same parameter types.
Signed-off-by: Keith Packard <keithp@keithp.com>
Add initial Controller architecture and design sections.
These are images contributed by Zephyr member companies and
collected over the various Face-to-Face meetings we have
been hold in the past years of Bluetooth Low Energy
Controller implementation.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Inform about the cs field change in struct spi_config. Also mention what
drivers must use from now on.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
Add spi_cs_is_gpio(_dt) helpers to check whether SPI CS is controlled by
GPIO or not. This both improves code readability and isolates SPI
internals.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
As of today it is not possible to use SPI dt-spec macros in C++,
something known and documented. The main reason is because `cs` property
is initialized using a compound literal, something not supported in C++.
This PR takes another approach, that is to not make `cs` a pointer but a
struct member. This way, we can perform a regular initialization, at the
cost of using extra memory for unused delay/pin/flags if `cs` is not
used.
Fixes#56572
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
Make some module variables static, limiting their scope and guaranteeing
zero-initialization. This allows to remove some redundant code as well.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
Tests if BLOB Client running on Friend Node can execute BLOB Transfer
with multiple LPNs running BLOB Server.
Signed-off-by: Krzysztof Kopyściński <krzysztof.kopyscinski@codecoup.pl>
This allows to establish friendship in othem tests outside of friendship
ones using same callbacks. This allows to avoid code duplication for
other tests that require friendship.
Signed-off-by: Krzysztof Kopyściński <krzysztof.kopyscinski@codecoup.pl>
This commit declares the missing `zephyr,flash` chosen field. Without
this, any Zephyr app is unable to compile properly for these boards.
This appeared after 48214e86b0.
Signed-off-by: Filip Kokosinski <fkokosinski@antmicro.com>
The help text indicates the range of value is 0-255, while the actual
maximum value acceptable is 100.
This commit updates the text to accurately reflect the acceptable
value range for the set_brightness API.
Signed-off-by: Chen Xingyu <hi@xingrz.me>
conn_mgr events cannot be used due to mistake in event definitions.
Fix these definitions so that events can be used.
Also patch hole in test coverage that allowed this in the first
place.
Signed-off-by: Georges Oates_Larsen <georges.larsen@nordicsemi.no>
This file adds the board overlay file for the `efr32xg24_dk2601b` board
to enable the `drivers.adc` test on this board.
Signed-off-by: Filip Kokosinski <fkokosinski@antmicro.com>
Replace custom macrology that was checking if any instance had the
int_gpios property with DT_ANY_INST_HAS_PROP_STATUS_OKAY.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
Add a new macro, DT_ANY_INST_HAS_PROP_STATUS_OKAY that given a property
name, evaluates to 1 if any enabled instance of `DT_DRV_COMPAT` has the
property or to zero if it hasn't.
This macro can be useful in the context of drivers to optimize
resources.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
Extend the sample to be built with native_posix
prevent issues like #57133 in the future. Also extends the qemu
build to build a "raw" configurationw without POSIX_API or
NET_SOCKETS_POSIX_NAMES.
Signed-off-by: Hein Wessels <heinwessels93@gmail.com>
Fixes the compiler error that occurs when attempting to build
the SNTP library with CONFIG_NET_SOCKETS_POSIX_NAMES=n, while
using native_posix.
Closes#57133
Co-authored-by: Chris Friedt <cfriedt@meta.com>
Signed-off-by: Hein Wessels <heinwessels93@gmail.com>
Fixes misspelling of `scans` in the description of `CONFIG_GEN_ISR_TABLES`
in the build system documentation.
Signed-off-by: Daniel Mangum <georgedanielmangum@gmail.com>
This adds callbacks for Secure and Private Network Beacons.
SNB callbacks are called after `secure_beacon_authenticate` ends
with success, and Private Beacon callback after Private Beacon
payload is decrypted succsessfully.
Signed-off-by: Krzysztof Kopyściński <krzysztof.kopyscinski@codecoup.pl>
The mps3 soc is missing PMU defines required for CMSIS. This
adds the defines __PMU_PRESENT and __PMU_NUM_EVENTCNT
enabling the api for the PMU.
Signed-off-by: Ryan McClelland <ryanmcclelland@meta.com>
Add TRNG support for BG27, which has slightly different register
definitions in HAL, compared to BG22.
Signed-off-by: Roman Dobrodii <rdobrodii@antmicro.com>
The '%ProgramFiles%' is not guaranteed to be 'C:\Program Files' on
Windows x64.
The value will be 'C:\Program Files (x86)' if the west is executed by
32-bit Python.
To correct the issue '%ProgramW6432%' must be used.
Signed-off-by: Georgij Cernysiov <geo.cgv@gmail.com>
