Replace the old master and slave prefixes with the new central and
peripehral ones from the Bluetooth spec v5.3.
Signed-off-by: Carles Cufi <carles.cufi@nordicsemi.no>
Fix missing reset of connection handle in the LLL context.
During a central connection, if LL reset is called, then
disabled connection context's handle has to be reset
otherwise new connection creation will fail by detecting
that there exists a connection to same peer.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
ULL reference count is checked in ULL_LOW context to decide
if LLL events are pending, but the reference count can be
decremented by the ULL HIGH execution context which can
prevent the set `disabled_cb` function not being called due
to no pending event to produce the done events.
Fixed by checking the reference count in the ULL HIGH
execution context using a mayfly to schedule the check.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
llcp.conn_param.ack was reset on tx of conn param rsp, however this
should only be done once the expected conn update ind is received
and sets the cu.ack flag to indicate cu procedure 'takes over'.
Signed-off-by: Erik Brockhoff <erbr@oticon.com>
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Add PDU time calculation macro for S2 and S8 Coded PHY.
Rename PKT_AC_US to PDU_AC_MAX_US.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Add struct ll_df_conn_rx_params sturcutre to struct lll_conn.
This is storage for parametrers required to configure radio
for CTE reception in connected mode by lower link layer.
Add required includes to make the controller code compilable
after change struct ll_conn.
Signed-off-by: Piotr Pryga <piotr.pryga@nordicsemi.no>
Add struct ll_df_conn_rx_params sturcutre to struct ll_conn.
This is storage for parametrers required to configure radio
for CTE reception in connected mode.
Add required includes to make the controller code compilable
after change struct ll_conn.
Signed-off-by: Piotr Pryga <piotr.pryga@nordicsemi.no>
Flush any pending Tx PDUs in the lower link layer before
enqueueing PHY_UPDATE_IND PDU with instant to ensure the
PDU is transmitted before the instant occurs.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Minor cleanup of the implementation of mutual exclusion
of LE Connection Parameter Request amongst active
connections.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Reserve a minimum node rx of 2 that can happen when local
central initiated PHY Update reserves 2 node rx, one for PHY
Update complete and another for Data Length Update complete
notification. Otherwise, a peripheral only needs 1
additional node rx to generate Data Length Update complete
when PHY Update completes.
Relates to #36381.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
When an ACL connection with active CISes terminates, inject CIS/CIG
teardown to ensure CIS is stopped before ACL disconnection completes.
This includes stopping CIG ticker when last CIS has stopped.
Signed-off-by: Morten Priess <mtpr@oticon.com>
Fix incorrect and redundant use of ticker user id ULL_LOW
instead of ULL_HIGH when setting up a connection using a
mayfly to disable LLL context. Also, the LLL context pointer
is invalid, where node rx is passed instead of LLL context.
Use the ULL disabled callback when done event has not yet
been processed, or a direct connection setup in ULL_HIGH
context when ULL is already disabled (reference count is
zero) is sufficient.
Regression introduced in commit 30f260dfaa ("Bluetooth:
controller: Fix adv/scan context access post release").
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Fix advertiser and scanning context being accessed on done
event when connection complete node rx that is processed
earlier has release them.
Relates to #30735.
Fixes#35013.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Replace the use of LL_FEAT define with ll_feat_get() so that
feature set value can be updated at runtime with host
feature bit values.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Refactor and simplify the bluetooth buffer configurations to improve the
easy of configurations and eliminate invalid ones.
By moving configurations out of host and controller specific
configurations and into a common one it becomes easier to configure
the host and controller separately as the same configurations can be
used as would be for a combined build.
All HCI configurations are now given exluding the matching HCI header,
which eases the configuration as the application don't have to know the
different header sizes.
The BT_RX_BUF_LEN is split into ACL and Event, as well as the suprising
use of Command size.
BT_L2CAP_RX_MTU is removed as the stack does not support reassembling of
HCI ACL data to larger L2CAP PDUs. The application will have to set
ACL RX size and account for the L2CAP PDU header itself.
BT_EATT_RX_MTU was removed as it is only used for setting a different
default value for another option which leads to the stuck kconfig symbol
problem.
The configurations can be updated according to the table below:
** New configuration | ** Old configuration
All configurations
BT_BUF_ACL_RX_SIZE | BT_L2CAP_RX_MTU + 4
BT_BUF_ACL_RX_SIZE | BT_RX_BUF_LEN - 4
BT_BUF_EVT_RX_SIZE | BT_RX_BUF_LEN - 2
BT_BUF_CMD_TX_SIZE | BT_RX_BUF_LEN - 3
BT_BUF_CMD_TX_COUNT | BT_HCI_CMD_COUNT
BT_BUF_EVT_RX_COUNT | BT_RX_BUF_COUNT
BT_BUF_ACL_RX_COUNT | BT_RX_BUF_COUNT
BT_BUF_ACL_RX_COUNT | BT_ACL_RX_COUNT
BT_BUF_EVT_DISCARDABLE_SIZE | BT_DISCARDABLE_BUF_SIZE - 2
BT_BUF_EVT_DISCARDABLE_COUNT | BT_DISCARDABLE_BUF_COUNT
Controller-build
BT_BUF_ACL_TX_SIZE | BT_CTLR_TX_BUFFERS_SIZE
BT_BUF_ACL_TX_COUNT | BT_CTLR_TX_BUFFER
HCI-bridge
BT_BUF_ACL_TX_SIZE | BT_HCI_ACL_DATA_SIZE
BT_BUF_ACL_TX_COUNT | 6
Fixed invalid configurations setting either BT_L2CAP_RX_MTU or
BT_CTLR_DATA_LENGTH_MAX larger than BT_RX_BUF_LEN could lead to buffer
overruns.
Fix advertising report max data length calculation.
This always used the BT_DISCARDABLE_BUF_SIZE macro but this feature
can be turned off and advertising reports will be allocated from the RX
buffer in that case. Also controller-build does not have this buffer
(in hci_raw.c). Also the wrong HCI header was used in the calculation,
HCI event header should have been used instead of HCI ACL header.
Signed-off-by: Joakim Andersson <joakim.andersson@nordicsemi.no>
Fix regression in central initiated terminate introduced in
commit 3a80785947 ("Bluetooth: controller: Fix connection
terminate to happen on event done").
The regression caused an additional central connection event
transmitting PDU after the previous connection event had
received acknowledgment for the terminate_ind PDU from the
peripheral.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Avoid possibly overflowing maximum interval when calculating interval
with preferred periodicity.
Changed calculation to round down from maximum interval and reset to
maximum in case of underflowing minimum interval.
Signed-off-by: Wolfgang Puffitsch <wopu@demant.com>
Moved sdu_interval struct members from llcp_cis to cis group,
to match spec and enable access by ULL
Signed-off-by: Asger Munk Nielsen <asmk@oticon.com>
Fix a missing encryption procedure state check which allowed
out of order receive of START_ENC_RSP PDU, which made the
controller to believe its already in an encryption procedure
in progress state.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Avoid using sizeof to access ULL and LLL struct members.
Based on the alignment requirements of structures, due to
padding between structure members, use of sizeof of previous
struct member to access next struct member is incorrect.
Continue to use explicitly stored parent pointer to access
ULL context. Combine event header and ULL header so that
the parent pointer point directly to the combined ULL
struct.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Fix conn_cleanup to be performed in the event done. The
regression was introduced in
commit 5412f61ac6 ("Bluetooth: controller: Introduce
separate done memq").
Now that done event is handled asynchronously outside the
handling of the terminate node rx type, it is necessary that
terminate node rx type is generated after the done event.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Renamed to BT_TICKER_LOW_LAT in ticker, and changed selected
conditionally compiled code to use IS_DEFINED macro.
Signed-off-by: Morten Priess <mtpr@oticon.com>
Conditional compile adv_addr which is only used by
controller when supporting initiator/central role.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Implemented LL_CIS_REQ/RSP and LL_CIS_IND handling to allow a central
to establish a CIS connection. Implementation is temporary, for
test/development purpose and should be re-implemented in the new LLCP
framework when ready.
Signed-off-by: Morten Priess <mtpr@oticon.com>
Fix control Tx buffer leak into data Tx pool that happens
after a cross-over control procedure response was paused due
to currently active encryption setup procedure, and a new
control Tx PDU in addition to the paused one is enqueued
thereafter.
When the control tx PDUs is resumed but not yet enqueued
towards the radio, if there is a new control Tx PDU enqueued
then the paused control Tx PDU is not set as the head of the
control PDUs in the Tx queue. This caused the paused control
Tx PDU to be associated with data Tx pool, hence causing the
incorrect release into data Tx pool.
Relates to the commit bff76b4cce ("Bluetooth: controller:
split: Fix control tx queue handling") and to the
commit 6991d09977 ("Bluetooth: controller: Fix control tx
queue handling").
Fixes#32898.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Ignore connection indications from peers that are already
connected. This is to bring the behavior of the controller in
accordance with [5.2, Vol 6, Part B, 4.5 Connection state]:
"If an advertiser receives a connection request from an initiator it
is already connected to, it shall ignore that request."
Signed-off-by: Wolfgang Puffitsch <wopu@demant.com>
Replace a development assertion in the implementation of
Connection Parameter Request Procedure with an internal
comment and handle transaction violation be ignoring the
PDU.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Remove inclusion of vendor specific internal LLL include
files in ULL source code.
Prefix `lll/` include file path to correctly include vendor
defined types and function implementation.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Add compilation guards for the feature_rsp_send function to avoid
compilation errors for some configurations.
Signed-off-by: Wolfgang Puffitsch <wopu@demant.com>
