The pm_constraint_* APIs were effectively used by the policy manager
only. This patch renames the API to the policy namespace and makes its
naming more explicit:
- pm_constraint_set -> pm_policy_state_lock_get()
- pm_constraint_release -> pm_policy_state_lock_put()
- pm_constraint_get -> pm_policy_state_lock_is_active()
The reason for these changes is that constraints can be of many types:
allow/disallow states, impose latency requirements, etc. The new naming
also makes explicit that the API calls will influence the PM policy
behavior.
All drivers and documentation have been updated accordingly.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
gpio_pin_interrupt_configure asserts that one of GPIO_INT_ENABLE or
_DISABLE is specified by the caller, and also that GPIO_INT_EDGE is
requested if both states (GPIO_INT_TRIG_BOTH) should interrupt. This
change corrects the misuses in it8xxx2 drivers that cause assertion
failures.
When assertions are disabled the existing code works correctly because
the it8xxx2 GPIO driver assumes that a pin interrupt should be enabled
if _DISABLE is not requested, and the driver only supports edge
triggers but assumes the absence of GPIO_INT_MODE_LEVEL indicates
an edge trigger was requested.
Signed-off-by: Peter Marheine <pmarheine@chromium.org>
Change-Id: I1aaee190ec4cf063f36e25c0c293a91d280e71bb
In order to align with macros used to obtain a device reference (e.g.
DEVICE_DT_GET), align the PM macros to use "GET" instead of "REF". This
change should have low impact since no official release has gone out yet
with the "REF" macros.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
If there are no console messages input at an interval of 15
seconds, the system will be able to enter suspend mode.
Signed-off-by: Tim Lin <tim2.lin@ite.corp-partner.google.com>
Port some drivers to the recently introduced macros to showcase its
usage and be able to do some initial testing (nRF52840).
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
IT8XXX2 uses shared ns16550.c driver which does not provide a power
management callback(pm_action_cb), so create driver to handle
IT8XXX2 specific UART features.
note: pm_action_cb(old name: pm_control_fn)
Signed-off-by: Tim Lin <tim2.lin@ite.corp-partner.google.com>
