Move to use DEVICE_DT_GET_ONE instead of device_get_binding as we
work on phasing out use of DTS 'label' property.
Signed-off-by: Kumar Gala <galak@kernel.org>
Move to use DEVICE_DT_GET_ONE instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Benjamin Björnsson <benjamin.bjornsson@gmail.com>
Move to use DEVICE_DT_GET_ONE instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Benjamin Björnsson <benjamin.bjornsson@gmail.com>
Move to use DEVICE_DT_GET_ONE instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Benjamin Björnsson <benjamin.bjornsson@gmail.com>
Extra steps for programming the external memory on nRF5340 DK are
no longer needed. Now west is capable of handling this itself.
Signed-off-by: Andrzej Głąbek <andrzej.glabek@nordicsemi.no>
Despite the comment it contains, the initialization procedure for
the external memory chip on nRF5340 DK does not enable the High
Performance Mode in the chip, so communication using a frequency
higher than 8 MHz fails and the sample crashes (it works only right
after programming the chip with nrfjprog, which enables the High
Performance Mode, but the chip returns to the Low Power mode after
the board is power-cycled).
This commit fixes the initialization procedure and performs some
additional clean-up.
Signed-off-by: Andrzej Głąbek <andrzej.glabek@nordicsemi.no>
In the Zephyr implementation, `sem_timedwait()` uses a
potentially wildly different timebase for comparison via
`k_uptime_get()` (uptime in ms).
The standard specifies `CLOCK_REALTIME`. However, the real-time
clock can be modified to an arbitrary value via clock_settime()
and there is no guarantee that it will always reflect uptime.
This change ensures that `sem_timedwait()` uses a more
consistent timebase for comparison.
Fixes#46807
Signed-off-by: Christopher Friedt <chrisfriedt@gmail.com>
Move to use DEVICE_DT_GET_ONE instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Benjamin Björnsson <benjamin.bjornsson@gmail.com>
Move to use DEVICE_DT_GET_ONE instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Benjamin Björnsson <benjamin.bjornsson@gmail.com>
Move to use DEVICE_DT_GET_ONE instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Benjamin Björnsson <benjamin.bjornsson@gmail.com>
Move to use DEVICE_DT_GET_ONE instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Benjamin Björnsson <benjamin.bjornsson@gmail.com>
Move to use DEVICE_DT_GET_ONE instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Benjamin Björnsson <benjamin.bjornsson@gmail.com>
Move to use DEVICE_DT_GET_ONE instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Benjamin Björnsson <benjamin.bjornsson@gmail.com>
Renaming objects which had 2 in the name to indicate that
it is v2 specific. Once logging v1 has been removed such
suffixes are redundant.
Signed-off-by: Krzysztof Chruscinski <krzysztof.chruscinski@nordicsemi.no>
This patch modifies the ADXL362 driver to use the new
SENSOR_TRIG_MOTION trigger for activity detection
and SENSOR_TRIG_STATIONARY for inactivity detection.
Signed-off-by: Maximilian Deubel <maximilian.deubel@nordicsemi.no>
Logging v1 has been removed and log_strdup wrapper function is no
longer needed. Removing the function and its use in the tree.
Signed-off-by: Krzysztof Chruscinski <krzysztof.chruscinski@nordicsemi.no>
Cocinelle complains about "shell" being used as a parameter name:
"Violation to rule 5.7 (Tag name should be unique) tag: shell"
Therefore rename the parameter throughout the sample to "sh".
Signed-off-by: Robert Lubos <robert.lubos@nordicsemi.no>
Rewrite the TCP/UDP download part of the zperf sample to use socket API.
For UDP, performance impact is negligible (< 1 Mbps), for TCP it's
noticable, but still throughputs can be considered satisfactory (up to
~75 Mbps).
Signed-off-by: Robert Lubos <robert.lubos@nordicsemi.no>
Rewrite TCP/UDP upload part of the zperf sample to use socket API
instead of net_context. This has a negligible impact on the upload
throughputs (< 1 Mbps).
Signed-off-by: Robert Lubos <robert.lubos@nordicsemi.no>
Whenever MBEDTLS_BUILTIN is selected then
CONFIG_MBEDTLS_CFG_FILE="config-tls-generic.h" is set as a default value.
Remove explicit configuration from prj_mtls_shim.conf.
Signed-off-by: Marcin Niestroj <m.niestroj@emb.dev>
Modified the samples such that the client will attempt to
setup 2 sink streams and 1 source stream, basically
representing a headset use case.
This also excercises both setting up a unidirectional
and a bidirectional ISO channel using the 3 audio streams.
Signed-off-by: Emil Gydesen <emil.gydesen@nordicsemi.no>
The sample used `net_buf_ref` to send the same data multiple
times on multiple streams, but the send procedure, which
ends up calling bt_conn_send_cb, does not work
with multiple refs. We thus replace the refs with net_buf_clones.
Signed-off-by: Emil Gydesen <emil.gydesen@nordicsemi.no>
This code has gone unmaintained and bugs continue to be reported
against it. We do not have the resources as a project to maintain this
in "odd fixes" mode, and nobody has stepped up to maintain it [1], so
sadly this must be removed for now.
If anyone would like to see civetweb supported in upstream Zephyr
again, they are welcome to add it back, as long as they promise to
maintain it going forward.
Many thanks to everyone who has contributed to civetweb support in
Zephyr while it was here. So long and thanks for all the fish.
Fixes: #45807Fixes: #43910Fixes: #34226Fixes: #46743
[1] https://lists.zephyrproject.org/g/devel/message/8466
Signed-off-by: Martí Bolívar <marti.bolivar@nordicsemi.no>
The value of CONFIG_SYS_CLOCK_TICKS_PER_SEC has side-effects that
are not expected with tickless kernel mode. In bug #46378, application
code is shown to run slower with higher sys clock tick value. In SOF
bug #5921, audio quality issues were root-caused to k_timer inaccuracy
with 50000 sys clock tick.
Set the the value to 15000 for all SOF applications. All existing
test cases pass with this value.
BugLink: https://github.com/zephyrproject-rtos/zephyr/issues/46378
BugLink: https://github.com/thesofproject/sof/issues/5921
Signed-off-by: Kai Vehmanen <kai.vehmanen@linux.intel.com>
Move to use DEVICE_DT_GET_ONE instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Benjamin Björnsson <benjamin.bjornsson@gmail.com>
The timeout was accidentally changed from 60 seconds
to 0.6 seconds.
This commit also fixes the number of prints, since we are now
sending at 10ms intervals.
Signed-off-by: Emil Gydesen <emil.gydesen@nordicsemi.no>
Samples peripheral_gatt_write and central_gatt_write to
demonstration use of GATT Write Command.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Update the readme for mpu_test sample to contain
correct sample outputs for mpu read, write and run operations.
Signed-off-by: Aastha Grover <aastha.grover@intel.com>
Move to use DEVICE_DT_GET_ONE instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Benjamin Björnsson <benjamin.bjornsson@gmail.com>
Move to use DEVICE_DT_GET_ONE instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Kumar Gala <galak@kernel.org>
Move to use DEVICE_DT_GET_ONE instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Benjamin Björnsson <benjamin.bjornsson@gmail.com>
The controller does not support connected ISO yet, so it does not make
sense to build it form devices that build both host and controller.
Signed-off-by: Rubin Gerritsen <rubin.gerritsen@nordicsemi.no>
Move to use DEVICE_DT_GET_ONE instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Benjamin Björnsson <benjamin.bjornsson@gmail.com>
Move to use DEVICE_DT_GET_ONE instead of device_get_binding as
we work on phasing out use of DTS 'label' property.
Signed-off-by: Kumar Gala <galak@kernel.org>
Move to use DEVICE_DT_GET instead of device_get_binding as we work
on phasing out use of DTS 'label' property.
Signed-off-by: Kumar Gala <galak@kernel.org>
Remove v1 implementation from log_core and all references in the tree.
Remove modules used by v1: log_list and log_msg.
Remove Kconfig v1 specific options.
Remove Kconfig flags used for distinction between v1 and v2.
Signed-off-by: Krzysztof Chruscinski <krzysztof.chruscinski@nordicsemi.no>
Files including <zephyr/kernel.h> do not have to include
<zephyr/zephyr.h>, a shim to <zephyr/kernel.h>.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
Move to use DEVICE_DT_GET_ONE instead of device_get_binding as we
work on phasing out use of DTS 'label' property.
Signed-off-by: Kumar Gala <galak@kernel.org>
...v1.1 overlay
Shows the dependencies which makes it easier to enable the content
format when necessary
Signed-off-by: Veijo Pesonen <veijo.pesonen@nordicsemi.no>
Enable I2C access to FXOS7000 sensor on the mixrt595_evk board
Tested using samples/sensor/fxos8700 for mimxrt595_evk_cm33.
Signed-off-by: Chay Guo <changyi.guo@nxp.com>
All the gpio drivers are based on devicetree and thus we always set
HAS_DTS_GPIO, thus we don't need this Kconfig option anymore. Remove
uses as its safe to assume DTS is supported for GPIO.
Signed-off-by: Kumar Gala <galak@kernel.org>
