MDIO is part of the ETH IP, but some phy chip may need a
specific phy driver to set up certain vendor registers enabling
particular features.
Add support for stm32 mdio access.
Signed-off-by: Angelo Dureghello <adureghello@baylibre.com>
MDIO controller is part of GMAC and it requires GMAC ethernet driver to
initialize first because it will reset the whole GMAC hw block during
initialization. Both C22 and C45 APIs are supported.
Co-authored-by: Benjamin Perseghetti <bperseghetti@rudislabs.com>
Signed-off-by: Manuel Argüelles <manuel.arguelles@nxp.com>
Signed-off-by: Benjamin Perseghetti <bperseghetti@rudislabs.com>
Add MDIO driver that works through GPIO pins. This driver is
useful when a microcontroller doesn't have MDIO bus or when multiple
separate MDIO buses are required. The driver provides access to
the MDIO bus through GPIO pins for any SoC that has GPIO pin control
available.
Signed-off-by: Aleksandr Senin <al@meshium.net>
Adds MDIO driver. Works via exposed
ADIN2111 functions.
It is possible to access Clause 45 and 22 registers.
Due to MDIO API limitation Clause 45 access
is done using driver specific MDIO functions.
Provides API and functions for PHY driver.
Signed-off-by: Georgij Cernysiov <geo.cgv@gmail.com>
Introduce NXP S32 NETC External MDIO controller driver. Driver supports
a single instance, as current support is based on NXP S32Z/E SoCs.
Signed-off-by: Manuel Arguelles <manuel.arguelles@nxp.com>
