These needed "memory" clobbers otherwise the compiler would do
unnecessary optimizations for parameters passed in as pointer
values.
Signed-off-by: Andrew Boie <andrew.p.boie@intel.com>
We now show the caller's thread ID and dump out the permissions array
for the object that failed the check.
Signed-off-by: Andrew Boie <andrew.p.boie@intel.com>
This API has a return value which was not being propagated back to the
caller if invoked as a system call.
Signed-off-by: Andrew Boie <andrew.p.boie@intel.com>
checkpatch expects typedefs to be suffixed with _t and has different
rules when typedefs are being used as arguments of a function. This
seems to be a known issue and defining typedefs in a file resolves this
issue.
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
$DTC wasn't exported, causing a build failure if it wasn't
defined outside the build system.
The provided ct-ng configuration files define
CT_TARGET_VENDOR="zephyr". Fix CROSS_COMPILE definition so
that the compiler can be found.
Change-Id: I4e25c775e1f02a435704b6a874adb221c677b13a
Signed-off-by: Andrew Boie <andrew.p.boie@intel.com>
This fixes following error:
ERROR: zephyr/.known-issues/doc/networking.conf: bytes 622-1441:
bad regex: bad escape \I at position 119 (line 2, column 2)
ERROR: E: zephyr/.known-issues/doc/networking.conf: can't load
config file: bad escape \I at position 119 (line 2, column 2)
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
As previous test without info, this one will be thrown with/without
receiver 1 and 2 times.
Signed-off-by: Tomasz Bursztyka <tomasz.bursztyka@linux.intel.com>
Adding net_mgmt_event_notify_with_info() which lets the event notifier
to pass dedicated data along with the event. The size of data that can
be passed must be limited to the biggest data passed (which will be
currently IPv6 + prefix).
Signed-off-by: Tomasz Bursztyka <tomasz.bursztyka@linux.intel.com>
If the LF clock was already started, but wasn't initialized with
_k32src_start yet, allow it to run once. This is needed because if a
soft reset is triggered while watchdog is active, the LF clock will
already be running, but won't be configured yet (watchdog forces LF
clock to be running).
If the LF clock isn't configured with _k32src_start, the nRF5 RTC
won't count and the whole system will malfunction, as the kernel
depends on the clock source being working properly.
Signed-off-by: Thiago Silveira <thiago@exati.com.br>
These are removed as the APIs that use them are not suitable for
exporting to userspace.
- Kernel workqueues run in supervisor mode, so it would not be
appropriate to allow user threads to submit work to them. A future
enhancement may extend or introduce parallel API where the workqueue
threads may run in user mode (or leave as an exercise to the user).
- Kernel slabs store private bookkeeping data inside the
user-accessible slab buffers themselves. Alternate APIs are planned
here for managing slabs of kernel objects, implemented within the
runtime library and not the kernel.
Signed-off-by: Andrew Boie <andrew.p.boie@intel.com>
k_pipe_block_put() will be done in another patch, we need to design
handling for the k_mem_block object.
Signed-off-by: Andrew Boie <andrew.p.boie@intel.com>
Use the define generated by the DTS instead of using the FLASH_ALIGN
alias. The latter is an internal mcuboot name. We shouldn't need it in
Zephyr itself.
Signed-off-by: Marti Bolivar <marti.bolivar@linaro.org>
Keep the flash shell up to date with the latest flash driver updates.
- Get the driver name from soc.h
- Add a write_block_size command
- Implement flash_shell_page_layout() using flash_page_foreach()
Signed-off-by: Marti Bolivar <marti.bolivar@linaro.org>
This patch adds a routine which can be used to iterate over all flash
pages on the device.
This can be also done by using flash_get_page_info_by_idx(), but that
would add an unnecessary loop over the layout array for each page.
Signed-off-by: Marti Bolivar <marti.bolivar@linaro.org>
This makes the SoC flash compatible with the common nonvolatile flash
YAML schema, and provides a write alignment. It mirrors work done on
nRF chips for the DFU subsystem.
Signed-off-by: Marti Bolivar <marti.bolivar@linaro.org>
This makes the SoC flash compatible with the common nonvolatile flash
YAML schema, and provides a write alignment. It mirrors work done on
nRF chips for the DFU subsystem.
Signed-off-by: Marti Bolivar <marti.bolivar@linaro.org>
This makes the SoC flash compatible with the common nonvolatile flash
YAML schema, and provides a write alignment. It mirrors work done on
nRF chips for the DFU subsystem.
Signed-off-by: Marti Bolivar <marti.bolivar@linaro.org>
This workaround fixes the issue that, after pin reset, RESETREAS bits
other than RESETPIN might also be set.
The workaround was added to both nRF52832 and nRF52840 SoCs.
Signed-off-by: Thiago Silveira <thiago@exati.com.br>
ZoAP tests are modified to use new CoAP API. Also modified tests
name from 'zoap' to 'coap'.
Signed-off-by: Ravi kumar Veeramally <ravikumar.veeramally@linux.intel.com>
Current coap library fails to parse or prepare if packet is more
than one fragment. Added support to handle multi fragment packet.
Also well-known/core api used to prepare coap packet and send it
through net context api immediately. This is goind to be problematic
if user doesn't enable net context. Also user can not encrypt coap
packets. Now api will return prepared coap packet to application.
Application will send it to peer.
Jira: ZEP-2210
Signed-off-by: Ravi kumar Veeramally <ravikumar.veeramally@linux.intel.com>
ZOAP library has certain limitations in parsing and preparation of
coap messages. It can handle only on single network fragment. If
network packet is split between multiple fragments it fails. This
patch is just copy and rename of 'zoap' to 'coap'.
Signed-off-by: Ravi kumar Veeramally <ravikumar.veeramally@linux.intel.com>
At 32 bytes the snprintk call to fill the help buffer was most often
running out of room and returning an error. Let's expand it to 64.
Signed-off-by: Michael Scott <michael.scott@linaro.org>
Users can private message the bot and the bot should respond directly
back to that user rather than rudely ignoring them.
Signed-off-by: Michael Scott <michael.scott@linaro.org>
Let's create a static global var for nickname so that we can use it
later without having to pass it all the way through callbacks, etc.
Also limit the size to 16 bytes as IRC servers will truncate anything
beyond.
Signed-off-by: Michael Scott <michael.scott@linaro.org>
These structures were originally intended to prototype an IRC library
which would be later moved into the subsys/net/lib/irc folder.
Unfortunately, that effort has faded and they make this code much more
complex than necessary. Let's remove them in favor of simplicity.
Signed-off-by: Michael Scott <michael.scott@linaro.org>
For style points let's declare the text shown at the beginning
of main() function to the top of our source as APP_BANNER so that
it's obvious and presents nicely.
Signed-off-by: Michael Scott <michael.scott@linaro.org>
Let's simplify the parsing function which scans incoming traffic
for carriage returns and let the net_pkt_read() function cross
multiple buffers if needed. Also, gracefully skip lines which
are longer than the command buffer.
Signed-off-by: Michael Scott <michael.scott@linaro.org>