95fb0ded6b
According to Kconfig guidelines, boolean prompts must not start with "Enable...". The following command has been used to automate the changes in this patch: sed -i "s/bool \"[Ee]nables\? \(\w\)/bool \"\U\1/g" **/Kconfig* Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
39 lines
1 KiB
Text
39 lines
1 KiB
Text
# SPDX-License-Identifier: Apache-2.0
|
|
|
|
menuconfig UART_STELLARIS
|
|
bool "Stellaris serial driver"
|
|
depends on SOC_TI_LM3S6965
|
|
select SERIAL_HAS_DRIVER
|
|
select SERIAL_SUPPORT_INTERRUPT
|
|
help
|
|
This option enables the Stellaris serial driver.
|
|
This specific driver can be used for the serial hardware
|
|
available at the Texas Instrument LM3S6965 board.
|
|
|
|
if UART_STELLARIS
|
|
|
|
# ---------- Port 0 ----------
|
|
|
|
config UART_STELLARIS_PORT_0
|
|
bool "Stellaris UART Port 0"
|
|
help
|
|
This tells the driver to configure the UART port at boot, depending on
|
|
the additional configure options below.
|
|
|
|
# ---------- Port 1 ----------
|
|
|
|
config UART_STELLARIS_PORT_1
|
|
bool "Stellaris UART Port 1"
|
|
help
|
|
This tells the driver to configure the UART port at boot, depending on
|
|
the additional configure options below.
|
|
|
|
# ---------- Port 2 ----------
|
|
|
|
config UART_STELLARIS_PORT_2
|
|
bool "Stellaris UART Port 2"
|
|
help
|
|
This tells the driver to configure the UART port at boot, depending on
|
|
the additional configure options below.
|
|
|
|
endif # UART_STELLARIS
|