6e8775ff84
Several reviewers agreed that DT_HAS_NODE_STATUS_OKAY(...) was an undesirable API for the following reasons: - it's inconsistent with the rest of the DT_NODE_HAS_FOO names - DT_NODE_HAS_FOO_BAR_BAZ(node) was agreed upon as a shorthand for macros which are equivalent to DT_NODE_HAS_FOO(node) && DT_NODE_HAS_BAR(node) && - DT_NODE_HAS_BAZ(node), and DT_HAS_NODE_STATUS_OKAY is an odd duck - DT_NODE_HAS_STATUS(..., okay) was viewed as more readable anyway - it is seen as a somewhat aesthetically challenged name Replace all users with DT_NODE_HAS_STATUS(..., okay), which is semantically equivalent. This is mostly done with sed, but a few remaining cases were done by hand, along with whitespace, docs, and comment changes. These special cases include the Nordic SOC static assert files. Signed-off-by: Martí Bolívar <marti.bolivar@nordicsemi.no>
85 lines
2.5 KiB
C
85 lines
2.5 KiB
C
/*
|
|
* Copyright 2017, 2020 NXP
|
|
*
|
|
* SPDX-License-Identifier: Apache-2.0
|
|
*/
|
|
|
|
#include <init.h>
|
|
#include <drivers/pinmux.h>
|
|
#include <fsl_port.h>
|
|
|
|
static int frdm_kw41z_pinmux_init(struct device *dev)
|
|
{
|
|
ARG_UNUSED(dev);
|
|
|
|
#ifdef CONFIG_PINMUX_MCUX_PORTA
|
|
struct device *porta =
|
|
device_get_binding(CONFIG_PINMUX_MCUX_PORTA_NAME);
|
|
#endif
|
|
#ifdef CONFIG_PINMUX_MCUX_PORTB
|
|
struct device *portb =
|
|
device_get_binding(CONFIG_PINMUX_MCUX_PORTB_NAME);
|
|
#endif
|
|
#ifdef CONFIG_PINMUX_MCUX_PORTC
|
|
struct device *portc =
|
|
device_get_binding(CONFIG_PINMUX_MCUX_PORTC_NAME);
|
|
#endif
|
|
|
|
/* Red, green, blue LEDs. Note the red LED and accel INT1 are both
|
|
* wired to PTC1.
|
|
*/
|
|
#if defined(CONFIG_PWM) && DT_NODE_HAS_STATUS(DT_NODELABEL(pwm0), okay)
|
|
pinmux_pin_set(portc, 1, PORT_PCR_MUX(kPORT_MuxAlt5));
|
|
pinmux_pin_set(porta, 19, PORT_PCR_MUX(kPORT_MuxAlt5));
|
|
pinmux_pin_set(porta, 18, PORT_PCR_MUX(kPORT_MuxAlt5));
|
|
#else
|
|
pinmux_pin_set(portc, 1, PORT_PCR_MUX(kPORT_MuxAsGpio));
|
|
pinmux_pin_set(porta, 19, PORT_PCR_MUX(kPORT_MuxAsGpio));
|
|
pinmux_pin_set(porta, 18, PORT_PCR_MUX(kPORT_MuxAsGpio));
|
|
#endif
|
|
|
|
#if DT_NODE_HAS_STATUS(DT_NODELABEL(i2c1), okay)
|
|
/* I2C1 SCL, SDA */
|
|
pinmux_pin_set(portc, 2, PORT_PCR_MUX(kPORT_MuxAlt3)
|
|
| PORT_PCR_PS_MASK);
|
|
pinmux_pin_set(portc, 3, PORT_PCR_MUX(kPORT_MuxAlt3)
|
|
| PORT_PCR_PS_MASK);
|
|
#endif
|
|
|
|
#if DT_NODE_HAS_STATUS(DT_NODELABEL(adc0), okay)
|
|
/* ADC0_SE3 */
|
|
pinmux_pin_set(portb, 2, PORT_PCR_MUX(kPORT_PinDisabledOrAnalog));
|
|
#endif
|
|
|
|
/* SW3, SW4 */
|
|
pinmux_pin_set(portc, 4, PORT_PCR_MUX(kPORT_MuxAsGpio));
|
|
pinmux_pin_set(portc, 5, PORT_PCR_MUX(kPORT_MuxAsGpio));
|
|
|
|
#if DT_NODE_HAS_STATUS(DT_NODELABEL(lpuart0), okay)
|
|
/* UART0 RX, TX */
|
|
pinmux_pin_set(portc, 6, PORT_PCR_MUX(kPORT_MuxAlt4));
|
|
pinmux_pin_set(portc, 7, PORT_PCR_MUX(kPORT_MuxAlt4));
|
|
#endif
|
|
|
|
#if DT_NODE_HAS_STATUS(DT_NODELABEL(spi0), okay)
|
|
/* SPI0 CS0, SCK, SOUT, SIN */
|
|
pinmux_pin_set(portc, 16, PORT_PCR_MUX(kPORT_MuxAlt2));
|
|
pinmux_pin_set(portc, 17, PORT_PCR_MUX(kPORT_MuxAlt2));
|
|
pinmux_pin_set(portc, 18, PORT_PCR_MUX(kPORT_MuxAlt2));
|
|
pinmux_pin_set(portc, 19, PORT_PCR_MUX(kPORT_MuxAlt2));
|
|
#endif
|
|
|
|
#if defined(CONFIG_PWM) && DT_NODE_HAS_STATUS(DT_NODELABEL(pwm1), okay)
|
|
pinmux_pin_set(porta, 0, PORT_PCR_MUX(kPORT_MuxAlt4));
|
|
pinmux_pin_set(porta, 1, PORT_PCR_MUX(kPORT_MuxAlt4));
|
|
#endif
|
|
|
|
#if defined(CONFIG_PWM) && DT_NODE_HAS_STATUS(DT_NODELABEL(pwm2), okay)
|
|
pinmux_pin_set(portb, 16, PORT_PCR_MUX(kPORT_MuxAlt4));
|
|
pinmux_pin_set(portb, 17, PORT_PCR_MUX(kPORT_MuxAlt4));
|
|
#endif
|
|
|
|
return 0;
|
|
}
|
|
|
|
SYS_INIT(frdm_kw41z_pinmux_init, PRE_KERNEL_1, CONFIG_PINMUX_INIT_PRIORITY);
|