0c6ccc0941
Before this fix the board init function were called too early, before the gpio driver was initialized. Because of the the board controller for the serial port was not enabled properly. This commit fixes this issue. Signed-off-by: Christian Taedcke <christian.taedcke@lemonbeat.com>
60 lines
1.1 KiB
C
60 lines
1.1 KiB
C
/*
|
|
* Copyright (c) 2020 Christian Taedcke
|
|
*
|
|
* SPDX-License-Identifier: Apache-2.0
|
|
*/
|
|
|
|
#include <init.h>
|
|
#include <drivers/gpio.h>
|
|
#include <sys/printk.h>
|
|
|
|
struct supply_cfg {
|
|
const struct device *gpio;
|
|
gpio_pin_t pin;
|
|
gpio_dt_flags_t flags;
|
|
};
|
|
|
|
static int enable_supply(const struct supply_cfg *cfg)
|
|
{
|
|
int rv = -ENODEV;
|
|
|
|
if (device_is_ready(cfg->gpio)) {
|
|
gpio_pin_configure(cfg->gpio, cfg->pin,
|
|
GPIO_OUTPUT | cfg->flags);
|
|
gpio_pin_set(cfg->gpio, cfg->pin, 1);
|
|
rv = 0;
|
|
}
|
|
|
|
return rv;
|
|
}
|
|
|
|
static int efr32mg_sltb004a_init(const struct device *dev)
|
|
{
|
|
struct supply_cfg cfg;
|
|
int rc = 0;
|
|
|
|
ARG_UNUSED(dev);
|
|
(void)cfg;
|
|
|
|
#define CCS811 DT_NODELABEL(ccs811)
|
|
|
|
#if DT_NODE_HAS_STATUS(CCS811, okay)
|
|
cfg = (struct supply_cfg){
|
|
.gpio = DEVICE_DT_GET(DT_GPIO_CTLR(CCS811, supply_gpios)),
|
|
.pin = DT_GPIO_PIN(CCS811, supply_gpios),
|
|
.flags = DT_GPIO_FLAGS(CCS811, supply_gpios),
|
|
};
|
|
|
|
/* Enable the CCS811 power */
|
|
rc = enable_supply(&cfg);
|
|
if (rc < 0) {
|
|
printk("CCS811 supply not enabled: %d\n", rc);
|
|
}
|
|
#endif
|
|
|
|
return rc;
|
|
}
|
|
|
|
/* needs to be done after GPIO driver init */
|
|
SYS_INIT(efr32mg_sltb004a_init, POST_KERNEL,
|
|
CONFIG_KERNEL_INIT_PRIORITY_DEVICE);
|