zephyr

History

Anas Nashif b5b8095749 samples: bluetooth and net samples need test setup remove build_only and make them depend on test harness (bluetooth) Signed-off-by: Anas Nashif <anas.nashif@intel.com>		2017-12-28 20:24:29 -05:00
..
src	kbuild: Removed KBuild	2017-11-08 20:00:22 -05:00
96b_nitrogen.overlay	samples: bluetooth: Set DT baud rate for nRF5x boards	2017-05-03 08:43:17 -05:00
CMakeLists.txt	cmake: Don't link with subsys__bluetooth unnecessarily	2017-12-19 12:46:03 -05:00
generic.conf	Bluetooth: Kconfig: Rename CONFIG_BLUETOOTH_* to CONFIG_BT_*	2017-08-09 11:14:19 +03:00
microbit.conf	Bluetooth: Kconfig: Rename CONFIG_BLUETOOTH_* to CONFIG_BT_*	2017-08-09 11:14:19 +03:00
nrf5.conf	Bluetooth: controller: Add DTM HCI commands	2017-09-04 06:08:09 -04:00
nrf51_blenano.overlay	samples: bluetooth: Set DT baud rate for nRF5x boards	2017-05-03 08:43:17 -05:00
nrf51_pca10028.overlay	samples: bluetooth: Set DT baud rate for nRF5x boards	2017-05-03 08:43:17 -05:00
nrf52_blenano2.overlay	samples: bluetooth: Set DT baud rate for nRF5x boards	2017-05-03 08:43:17 -05:00
nrf52_pca10040.overlay	samples: bluetooth: Set DT baud rate for nRF5x boards	2017-05-03 08:43:17 -05:00
nrf52840_pca10056.overlay	samples: bluetooth: Set DT baud rate for nRF5x boards	2017-05-03 08:43:17 -05:00
README.rst	doc: add labels to bluetooth sample docs	2017-04-04 19:51:27 +00:00
sample.yaml	samples: bluetooth and net samples need test setup	2017-12-28 20:24:29 -05:00

README.rst

.. _bluetooth-hci-uart-sample:

Bluetooth: HCI UART
####################

Overview
*********

Expose Zephyr Bluetooth Controller support over UART to another device/CPU using
the H:4 HCI transport protocol (requires HW flow control from the UART)



Requirements
************

* BlueZ running on the host, or
* A board with BLE support

Building and Running
********************
This sample can be found under :file:`samples/bluetooth/hci_uart` in the
Zephyr tree.

See :ref:`bluetooth setup section <bluetooth_setup>` for details.