7d5215ff19
Update serial drivers to use DT_HAS_<compat>_ENABLED Kconfig symbol to expose the driver and enable it by default based on devicetree. We remove 'depend on' Kconfig for symbols that would be implied by the devicetree node existing. Signed-off-by: Kumar Gala <galak@kernel.org>
41 lines
1 KiB
Plaintext
41 lines
1 KiB
Plaintext
# SPDX-License-Identifier: Apache-2.0
|
|
|
|
menuconfig UART_STELLARIS
|
|
bool "Stellaris serial driver"
|
|
default y
|
|
depends on DT_HAS_TI_STELLARIS_UART_ENABLED
|
|
select SERIAL_HAS_DRIVER
|
|
select SERIAL_SUPPORT_INTERRUPT
|
|
help
|
|
This option enables the Stellaris serial driver.
|
|
This specific driver can be used for the serial hardware
|
|
available at the Texas Instrument LM3S6965 board.
|
|
|
|
if UART_STELLARIS
|
|
|
|
# ---------- Port 0 ----------
|
|
|
|
config UART_STELLARIS_PORT_0
|
|
bool "Stellaris UART Port 0"
|
|
help
|
|
This tells the driver to configure the UART port at boot, depending on
|
|
the additional configure options below.
|
|
|
|
# ---------- Port 1 ----------
|
|
|
|
config UART_STELLARIS_PORT_1
|
|
bool "Stellaris UART Port 1"
|
|
help
|
|
This tells the driver to configure the UART port at boot, depending on
|
|
the additional configure options below.
|
|
|
|
# ---------- Port 2 ----------
|
|
|
|
config UART_STELLARIS_PORT_2
|
|
bool "Stellaris UART Port 2"
|
|
help
|
|
This tells the driver to configure the UART port at boot, depending on
|
|
the additional configure options below.
|
|
|
|
endif # UART_STELLARIS
|