df81fef944
This change in pattern is meant to address a misconfiguration issue that can occur for sensors that support being on multiple busses like I2C & SPI. For example, you can have a configuration in which such a sensor is on the I2C bus in the devicetree and the sensor is enabled. However the application configuration enables CONFIG_SPI=y and CONFIG_I2C=n and this will cause the sensor driver to be built by default, however since we don't have the I2C bus enabled the driver will not compile correctly. Previously we had been adding to board Kconfig.defconfig something like: config I2C default y if SENSOR This pattern doesn't scale well and may differ from what an application specific need/use is. So instead move to a pattern in which we leave the default enablement up to the devicetree "status" property for the sensor. We then have the Kconfig move from 'depends on <BUS>' to 'select <BUS>' and in the case of drivers that support multiple busses we have the Kconfig be: 'select <BUS> if $(dt_compat_on_bus,$(<DT_COMPAT>),<BUS>) for each bus type the sensor supports. This removes the need to add Kconfig logic to each board and enables the bus subsystem and bus controller driver if the sensor requires it by default in the build system. Fixes: #48518 Signed-off-by: Kumar Gala <galak@kernel.org>
55 lines
1.1 KiB
Plaintext
55 lines
1.1 KiB
Plaintext
# AMG88XX infrared thermopile sensor configuration options
|
|
|
|
# Copyright (c) 2017 Phytec Messtechnik GmbH
|
|
# SPDX-License-Identifier: Apache-2.0
|
|
|
|
menuconfig AMG88XX
|
|
bool "AMG88XX Infrared Thermopile Sensor"
|
|
default y
|
|
depends on DT_HAS_PANASONIC_AMG88XX_ENABLED
|
|
select I2C
|
|
help
|
|
Enable driver for AMG88XX infrared thermopile sensor.
|
|
|
|
if AMG88XX
|
|
|
|
choice
|
|
prompt "Trigger mode"
|
|
default AMG88XX_TRIGGER_NONE
|
|
help
|
|
Specify the type of triggering used by the driver.
|
|
|
|
config AMG88XX_TRIGGER_NONE
|
|
bool "No trigger"
|
|
|
|
config AMG88XX_TRIGGER_GLOBAL_THREAD
|
|
bool "Use global thread"
|
|
depends on GPIO
|
|
select AMG88XX_TRIGGER
|
|
|
|
config AMG88XX_TRIGGER_OWN_THREAD
|
|
bool "Use own thread"
|
|
depends on GPIO
|
|
select AMG88XX_TRIGGER
|
|
|
|
endchoice
|
|
|
|
config AMG88XX_TRIGGER
|
|
bool
|
|
|
|
config AMG88XX_THREAD_PRIORITY
|
|
int "Thread priority"
|
|
depends on AMG88XX_TRIGGER_OWN_THREAD
|
|
default 10
|
|
help
|
|
Priority of thread used by the driver to handle interrupts.
|
|
|
|
config AMG88XX_THREAD_STACK_SIZE
|
|
int "Thread stack size"
|
|
depends on AMG88XX_TRIGGER_OWN_THREAD
|
|
default 1024
|
|
help
|
|
Stack size of thread used by the driver to handle interrupts.
|
|
|
|
endif # AMG88XX
|