zephyr

History

Manuel Argüelles 5d2670ac1f drivers: pwm: mcux_ftm: allow to select clock source FTM internal counter can be clocked by one of three clock sources independent of the module bus clock. This patch introduces a DT property to perform the clock selection from DT. DT sources are updated to keep the current clock selection for all boards, with exception of ucans32k1sic board which is migrated to use system clock by default, as this seems to be a better choice for most cases. Some PWM LED samples require slower clock so overlays are added for those cases. Signed-off-by: Manuel Argüelles <manuel.arguelles@nxp.com>		2024-04-19 10:08:53 +02:00
..
boards	drivers: pwm: mcux_ftm: allow to select clock source	2024-04-19 10:08:53 +02:00
src	samples, tests, boards: Switch main return type from void to int	2023-04-14 07:49:41 +09:00
CMakeLists.txt	samples and tests: Add REQUIRED to Zephyr find_package call	2023-03-02 09:58:27 +01:00
prj.conf	samples: drivers: led_pwm: enable immediate logging mode	2023-01-02 13:03:46 +01:00
README.rst	doc: driver: samples: Update driver samples to use new Sphinx extension	2023-09-22 09:21:43 +02:00
sample.yaml	samples: drivers: led_pwm: Update driver to remove DEVICE_DT_GET	2022-07-23 11:39:11 -05:00

README.rst

.. zephyr:code-sample:: led-pwm
   :name: LED PWM
   :relevant-api: led_interface

   Control PWM LEDs using the LED API.

Overview
********

This sample allows to test the led-pwm driver. The first "pwm-leds" compatible
device instance found in DT is used. For each LEDs attached to this device
(child nodes) the same test pattern (described below) is executed. The LED API
functions are used to control the LEDs.

Test pattern
============

For each PWM LEDs (one after the other):

- Turning on
- Turning off
- Increasing brightness gradually
- Blinking on: 0.1 sec, off: 0.1 sec
- Blinking on: 1 sec, off: 1 sec
- Turning off

Building and Running
********************

This sample can be built and executed on all the boards with PWM LEDs connected.
The LEDs must be correctly described in the DTS: the compatible property of the
device node must match "pwm-leds". And for each LED, a child node must be
defined and the PWM configuration must be provided through a "pwms" phandle's
node.