6a4ebe5949
Add support for the SX126x series of LoRa radios using the LoRaMAC-Node HAL. This driver currently makes the following assumptions: * DIO1 is used as an interrupt line. * There is an RF switch selecting between the TX and RX ports and that switch is controlled by DIO2. * There is either no TCXO or the TCXO is controlled by DIO3. Specifically, the limitations above mean that modules that use GPIOs to control the RF switch are currently not supported. Support for such modules would need changes to the LoRaMAC-Node code. Signed-off-by: Andreas Sandberg <andreas@sandberg.pp.se>
24 lines
484 B
Plaintext
24 lines
484 B
Plaintext
#
|
|
# Copyright (c) 2019 Manivannan Sadhasivam
|
|
#
|
|
# SPDX-License-Identifier: Apache-2.0
|
|
#
|
|
|
|
config HAS_SEMTECH_LORAMAC
|
|
bool "Semtech LoRaMac Stack"
|
|
help
|
|
This option enables the use of Semtech's LoRaMac stack
|
|
|
|
config HAS_SEMTECH_RADIO_DRIVERS
|
|
bool "Semtech LoRa Radio Drivers"
|
|
help
|
|
This option enables the use of Semtech's Radio drivers
|
|
|
|
config HAS_SEMTECH_SX1276
|
|
bool
|
|
depends on HAS_SEMTECH_RADIO_DRIVERS
|
|
|
|
config HAS_SEMTECH_SX126X
|
|
bool
|
|
depends on HAS_SEMTECH_RADIO_DRIVERS
|