Update interface of memc flexspi driver to better handle multiple
devices. Previously, using multiple devices on one FlexSPI bus would
require the user to configure each device to install its command table
(referred to as a LUT table by the driver) at an offset, so that it did
not overlap with other devices on the bus.
This commit changes the interface of the memc flexspi driver to instead
configure the LUT and flash device in one call. This allows the memc
driver to record the port each LUT sequence is used with, so that
future FlexSPI transfer requests can have their LUT offsets adjusted
based on the target port (which will correspond to a target device)
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
Check XIP state based on the value of CONFIG_FLASH_BASE_ADDRESS. This
check should be more reliable than the SOC based method currently
used.
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
MEC172X series SoCs share most IP but the -LJ series expands the PWM and
ADC channels available as well as defines extra pinctrl pins.
Separating these better to be able to simplify their inclusion and
driver code. Any board based on either the -SZ or -LJ package can just
include the mec172x<sz/lj> dtsi files for their specific package.
Signed-off-by: Jeff Daly <jeffd@silicom-usa.com>
add support for the sigev_thread flag in zephyr timer posix api following
the behaviour described in the linux man page. with this enhancement,
a single thread is created to receive all notifications from timers
Signed-off-by: Arunmani Alagarsamy <arunmani@linumiz.com>
This commit adds board files for the da14695_dk_usb.
The board features two Mikrobus sockets, these are added to the dts
Signed-off-by: Niek Ilmer <niek.ilmer.aj@renesas.com>
This commits adds the DA14695 variant.
The main difference with the DA14699 is a smaller package with less
GPIO.
Signed-off-by: Niek Ilmer <niek.ilmer.aj@renesas.com>
Add the following XPRO boards to flash driver test:
SAMD20, SAMDE54 and SAMR21
Signed-off-by: Daniel Evans <photonthunder@gmail.com>
Co-authored-by: Gerson Fernando Budke nandojve@gmail.com
Rename the Kconfig option from BT_ISO_ADVANCED to
BT_ISO_TEST_PARAMS to more explicitly denote that it
enables support for using the ISO test parameters.
Signed-off-by: Emil Gydesen <emil.gydesen@nordicsemi.no>
Add Zephyr 3.5 as a supported release until July 26th 2024, i.e. when
3.7 is planned to be released.
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>
Use Noto as baseline font and Inconsolata Nerd Font for source code.
These are both esthetically pleasing and have good Unicode coverage.
NOTE: Unsupported characters (i.e. emojis, at the time of this commit)
are rendered as tofu (i.e. a square).
Signed-off-by: Benjamin Cabé <benjamin@zephyrproject.org>
XeLaTeX is a TeX typesetting engine that extends LaTeX with support for
Unicode and modern font technologies such as OpenType.
It is included in all the LaTeX distro recommended for Zephyr so it is
safe to assume it is available to the user interested in building the
PDF documentation locally
Signed-off-by: Benjamin Cabé <benjamin@zephyrproject.org>
This is needed since commit f66b73197d
("drivers: hwspinlock: implement sqn hwspinlock driver") started
using it. Not sure how this got past CI.
Signed-off-by: Martí Bolívar <mbolivar@amperecomputing.com>
Add note to migration guide describing how to instantiate a ramdisk
using devicetree, and calling out Kconfig options that have been removed
with this change
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
Become the maintainer for the jwt/json code. The json code has been in
tree for a while, and I am the author of the jwt code.
Signed-off-by: David Brown <david.brown@linaro.org>
Add migration guide notes for i.MX RT boards, including the following
changes:
- i.MX RT boards must now manually enable
CONFIG_DEVICE_CONFIGURATION_DATA and CONFIG_NXP_IMX_EXTERNAL_SDRAM
when required
- SNVS pin names have changed for i.MX RT11xx series boards
Signed-off-by: Daniel DeGrasse <daniel.degrasse@nxp.com>
Reorder the sections so that the core/wide impact ones come first (e.g.
Kernel and C-Library) and more specific ones (e.g. architectures) come
last.
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>
Add sections to the migration guide to make it easier to spot and follow
suggestions of specific areas.
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
Fix typo in nsim_hs6x_smp_12cores platform name (as previously
we had nsim_hs5x_smp_12cores platform mentioned two times)
Signed-off-by: Eugeniy Paltsev <Eugeniy.Paltsev@synopsys.com>
Signed-off-by: Evgeniy Paltsev <PaltsevEvgeniy@gmail.com>
Reword VPX part as was requested by @abrodkin
Signed-off-by: Eugeniy Paltsev <Eugeniy.Paltsev@synopsys.com>
Signed-off-by: Evgeniy Paltsev <PaltsevEvgeniy@gmail.com>
Added explicit code blocks throughout the document.
Removed several incorrect uses of "console" language where it should have
been shell or bat.
"console" is only for _bash_ sessions that include a prompt.
Signed-off-by: Benjamin Cabé <benjamin@zephyrproject.org>
The 'console' language in pygments is for Bash shell session, i.e code
snippets were commands MUST start with a prompt.
The commands rendered by the ZephyrAppCommandsDirective do not include
a prompt, and should therefore be set as "shell".
Signed-off-by: Benjamin Cabé <benjamin@zephyrproject.org>
