Generic node_rx_hdr struct contains data not used for done event, so this
pdu specific data is moved to node_rx_pdu to minimize memory usage for
MFIFO_done alloc.
This however calls for a considerable write-through replacing the generic
node_rx_hdr with node_rx_pdu when relevant and needed.
Signed-off-by: Erik Brockhoff <erbr@oticon.com>
Add HCI input parameter validation according to spec for passing
qualification tests.
- Conditional compile of LE Set PA Receive Enable feature
- Store BIGinfo encryption state and number of streams
- Do not report BIGinfo if phy is invalid or unsupported
- Return disallowed ll_read_iso_tx_sync uses sync recever handle
- Validate BIS indices in ll_big_sync_create
Signed-off-by: Morten Priess <mtpr@oticon.com>
Advertising data has to be truncated at a PDU boundary
Similar to earlier fix for extended advertising reports
Found in several EBQ tests, including LL/DDI/SCN/BV-25-C,
LL/DDI/SCN/BV-21-C and LL/DDI/SCN/BV-46-C
Signed-off-by: Troels Nilsson <trnn@demant.com>
Fix assertion due to LLL scheduling of auxiliary PDU
reception was not considered in the ULL when checking for
accumulated data length exceeding the supported maximum scan
data length. This caused the auxiliary context to be release
while LLL was still active with scheduled PDU reception.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Fix periodic advertising sync window calculation to include
the scheduling resolution margin, i.e. be double as with
the event jitter value.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Reduce number of successive calls to ticker_job() by
disabling mayflies in the ULL_HIGH priority, enqueue
ticker_yield_abs() and ticker_start() before re-enabling
so that single ticker_job() handles both yield and start.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
If the aux scanner already has CONFIG_BT_CTLR_SCAN_DATA_LEN_MAX
advertising data, there is no point in following an aux ptr -
instead flush the data and produce an incomplete report
Signed-off-by: Troels Nilsson <trnn@demant.com>
Use CONFIG_BT_CTLR_PHY_CODED to flag out coded phy code
Don't schedule a scan for coded phy when it is not supported
Signed-off-by: Troels Nilsson <trnn@demant.com>
In order to have clean, self-contained HCI headers that do not have any
dependencies towards the Host or any other part of the system (except
types), reorganize the headers in the following way:
- Split out the macros and structs from hci.h to a new hci_types.h
- Merge the existing hci_err.h into the new hci_types.h
Fixes#58214.
Signed-off-by: Carles Cufi <carles.cufi@nordicsemi.no>
Bitsets across byte boundaries does not work properly for big-endian;
Converted to use two uint8's instead
Signed-off-by: Troels Nilsson <trnn@demant.com>
Make Data, ISO, BIS and CIS PDU structure's octet 3 vendor
specific.
This will allow vendors not supporting the octet 3 or
CTEInfo (8 bits) to save 1 octet in their PDU structures.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
The `bluetooth/common/log.h` and `bluetooth/common/log.c` files have been
removed. Files that were using them have been updated to use
`zephyr/logging/log.h` instead.
Those replacement have been done consequently:
- `/BT_DBG/LOG_DBG/`
- `/BT_ERR/LOG_ERR/`
- `/BT_WARN/LOG_WRN/`
- `/BT_INFO/LOG_INF/`
- `/BT_HEXDUMP_DBG/LOG_HEXDUMP_DBG/`
- `/BT_DBG_OBJ_ID/LOG_DBG_OBJ_ID/`
Also, some files were relying on the `common/log.h` include to include
`zephyr/bluetooth/hci.h`, in those cases the include of `hci.h` has
been added.
For files that were including `common/log.h` but not using any logs,
the include has been removed and not replaced.
Signed-off-by: Théo Battrel <theo.battrel@nordicsemi.no>
If scan is being disabled, rx could already be enqueued
before coming to ull_scan_aux_rx_flush. Check if node rx is
not the last in the list of received PDUs then add it to the
list, else do not add it to the list to avoid duplicate
report generation, release and probable infinite loop
processing of the list. It is possible that node rx has not
be already added in case of last PDU in the chain, under
this case when scan is being stopped add it to the list
before auxiliary context is flushed.
Add the node rx to aux context list of node rx if not
already added when coming to ull_scan_aux_rx_flush. This is
handling a race condition wherein the last PDU in chain is
received and at the same time scan is being disabled.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Fix scan aux context leak on Periodic Sync Terminate. On
Periodic Sync Terminate the `is_stop` flag is set to prevent
the ULL from assigning an aux context to the sync context,
but the acquired aux context was neither assigned to sync
context nor was being released back to the aux context pool.
Fixed by releasing the aux context if not assigned to the
sync context when `is_stop` flag is set.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
According to Bluetooth 5.3 Vol 4, Part E section 7.7.65.21 the
Controller should send an IQ report with Packet_Status set to 0xFF
and Sample_Count to 0x0, to inform Host that it is not able to
store IQ samples for all received Constant Tone Extensions and has
failed to sample at least once.
This commit adds handling of such situation for direction finding
in connectionless mode in lower link layer. It includes:
- lack of node_rx_iq_report to store IQ samples,
- lack of free node_rx to report received advertising data (generates
an advertising data report with indication "incomplete, no more to
come" and cancels reception of chained PDUs,
- cancellation of chained PDUs reception due to other scheduling
reasons.
In all of these situations CTE reception must be enabled and number of
received CTEs is smaller than requested by Host.
If there is not sufficient number of node_rx_iq_report nodes and
report was generated, the CTE will not be samples in a given
periodic advertising synchronization event. The CTE will be
sampled again in next event if there are node_rx_iq_report available.
End user applications may check periodic advertising sync event
counter when use of the reports to be sure about sync event
the received report is connected with.
Signed-off-by: Piotr Pryga <piotr.pryga@nordicsemi.no>
Fix Extended Scanning assertion check when using Ticker
Low Latency Implementation where the failure to schedule
a ticker timeout is returned inline compared to deferred
failure in the operation callback.
Auxiliary PDU is received using a single-shot ticker
timeout with ticks_slot reservation. This single-shot
ticker is allowed to fail if it is overlapping another
event.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Add Kconfig to use minimal time reservation for auxiliary
and sync PDU reception. A peer device could be scheduling
multiple advertising sets in a short duration with small
PDUs hence using the minimal time reservation would avoid
skipping closely scheduled reception of multiple auxiliary
PDUs.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Use minimal time reservation for auxiliary and sync PDU
reception. A peer device could be scheduling multiple
advertising sets in a short duration with small PDUs hence
using the minimal time reservation would avoid skipping
closely scheduled reception of multiple auxiliary PDUs.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Fix Periodic Advertising Synchronization from being
preempted by an overlapping Auxiliary PDU scan event.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
In order to bring consistency in-tree, migrate all subsystems code to
the new prefix <zephyr/...>. Note that the conversion has been scripted,
refer to zephyrproject-rtos#45388 for more details.
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
Fix Extended Scan disable and Periodic Synchronization
terminate to cover scenarios where chain PDU reception could
complete while thread context is waiting for the radio event
to be done.
Changes here ensure auxiliary context is not released twice
which is caught as an assertion in flush() when checking for
validity of aux->parent pointer.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Add additional assertion check in the control path leading
to auxiliary context release to catch regressions that may
lead to duplicate auxiliary context release.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
NULL structure fields before releasing memory back to pool.
Add assertion check to prevent NULL pointer dereferencing of
node rx.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Fix scan aux context release when (ULL) ticker scheduling
fails due to overlapping events (example a new scan window)
and aux context being released before scan aux done event is
processed, caused assertion when processing the done event
with corrupt ULL reference count.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Use ticker yield interface to allow chain PDU reception that
overlaps with currently reserved time for received PDU.
Without the yield ULL scheduling to receive auxiliary PDU
fails to be scheduled using ticker.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Fix missing use of EVENT_TICKER_RES_MARGIN_US and receive
chain delay in the calculation of overhead value that
determines if ULL or LLL scheduling to be used to receive
auxiliary PDUs.
Also, fix missing use of EVENT_TICKER_RES_MARGIN_US when
ULL scheduling for reception of auxiliary PDU.
See also commit 544acb9804 ("Bluetooth: controller: Fix
missing EVENT_TICKER_RES_MARGIN_US").
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Fix uninitialized param field when generating incomplete
no more data to come periodic advertising report.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Fix auxiliary context from being flushed when scanner or
periodic synchronization is stopped, to avoid using the
disable_cb by both. Fixes an assertion when this race
condition happens.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Do not enqueue NODE_RX_TYPE_RELEASE into Auxiliary context
when stopping scanner, as this type is not to be passed to
HCI processing, which would lead to assertion.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Fix auxiliary context leak on stop, under race condition
where ULL High execution context does not release the
auxiliary context as stop has been requested, and done
has decremented the auxiliary context's reference count.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Add development assert to check the validity of auxiliary
context allocation. This is to ensure that primary PDU
reception does not have an auxiliary context allocated until
ULL has processed the node rx.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Add development assert to check the validity of auxiliary
context's parent. This is to ensure a released auxiliary
context is not reused without allocation.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Fix any stray Extended Auxiliary PDU from being scanned
when disabling Extended Scanning.
Updated Extended Scan disable implementation to find any
active auxiliary scan context and stop them.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Fix Periodic Sync Terminate implementation for race
conditions with ULL scheduling by using a flag to stop any
new ULL scheduling to receive chain PDUs.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Fix duplicate incomplete data status generated for Periodic
Advertising Report when LLL scheduling is used but auxiliary
context failed to be allocated in ULL.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Fix missing progression of the rx_last pointer when
appending rx buffers before flushing them towards Host.
Under continuous scanning, as the disabled_cb would only
be called when reference count reaches zero, the rx_last
pointer needs to progress when appending the rx buffers.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
