Set AMP dts nodes (ipm, mbox, ...) to use fixed locations in reserved
memory areas. Those areas memories are delimited in the `memory.h`.
Size of the occupied areas can be calculated but the dts nodes addresses
needs to be set manually in every case.
Signed-off-by: Marek Matej <marek.matej@espressif.com>
* Replace copies of fixed-partitions nodes in related boards by
referencing the apropriate partition table from the available list.
* For better reference the `partitions_*.dtsi` file has boot offset,
purpose and the flash size encoded in the file name. Default flash size
is considered to be 4MB.
* Added the flash size node for the boards which are not based on the
module.
* Removed flash size registry from the esp32.*common.dtsi
Signed-off-by: Marek Matej <marek.matej@espressif.com>
Align the shared memories with the memory.h layout.
Reorder nodes to show memory related nodes together.
Signed-off-by: Marek Matej <marek.matej@espressif.com>
I2S driver was merged after interrupt .dtsi was changed,
causing CI to fail. This updates it accordingly.
Signed-off-by: Sylvio Alves <sylvio.alves@espressif.com>
This WDT is responsible for monitoring the external
32.728 Hz crystal connected to pins XTAL_32K_P and
XTAL_32K_N. If an oscillation failure is detected
the hardware automatically switch to RTC_RC_SLOW
clock source and triggers an interrupt.
Signed-off-by: Lucas Tamborrino <lucas.tamborrino@espressif.com>
The RTC subsystem in espressif's SOCs, among other tasks
is responsible for clock selection for CPU and for low
power domain clocks such as RTC_SLOW and RTC_FAST.
This commit allows for proper clock source and rate
selection for CPU, using the espressif,riscv and
espressif,xtensa-lx6/7 bindings.
It also enables clock selection for RTC_FAST and RTC_SLOW,
that impacts some peripherals, such as rtc_timer.
Signed-off-by: Lucas Tamborrino <lucas.tamborrino@espressif.com>
Remove all optional, initial CAN sample point properties and rely on the
CAN timing calculations to automatically pick the preferred sample point
location based on the initial bitrate.
Signed-off-by: Henrik Brix Andersen <hebad@vestas.com>
Update the descriptions for the various CAN devicetree timing properties
specified in Time Quanta (TQ) to make it clear that these, if present, are
only used for the initial timing parameters.
Deprecate the (Re-)Synchronization Jump Width (SJW) devicetree properties
for both arbitration and data phase timing as these are now only used in
combination with the other TQ-based CAN timing properties, which are all
deprecated.
Signed-off-by: Henrik Brix Andersen <hebad@vestas.com>
Introduce dtsi files representing the
current portfolio of chips and modules
based on the followint criteria:
- flash size
- psram size
- gpio count
- certification status
Update the boards dts files according
to which SOC/SIP they are using.
Signed-off-by: Marek Matej <marek.matej@espressif.com>
2023-07-25 18:12:33 +02:00
Renamed from dts/xtensa/espressif/esp32s3.dtsi (Browse further)
