There's now snprintk available that's more light-weight on the stack
than snprintf.
Change-Id: I6b3e4409703ca92fe6b8f4146ff47c490ab826cb
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>
Using the K_* macros makes it easier to read what exactly the various
timeouts are.
Change-Id: Ia405d3760b8e600af7e33a7221ef6ec717708973
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>
Switch to using k_work and k_delayed_work APIs.
Change-Id: I3be18132cc417607adaec0ad711256b94e314c38
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>
Don't use the deprecated NANOKERNEL init level. The only requirement
for Bluetooth drivers is for them to be registered before the
application main() runs, so POST_KERNEL should be good enough.
Change-Id: I02a8609bf63e9d608b802576214a2e76211b3965
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>
Use the unified kernel API k_sleep() instead of the deprecated
fiber_sleep().
Change-Id: I587d72ca5b53aacc02647b32c3ebceb1d7fe067e
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>
Switch to using the unified kernel k_thread_spawn() API instead of
nano_fiber_start().
Change-Id: I325cf467ae2a52c6aec8fc166397c323929e3013
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>
Use the unified kernel API k_yield() instead of fiber_yield().
Change-Id: I8f52031f52f7ac8783033a51751dc22decdfa59a
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>
Use defines from k_fifo intead of legacy API.
Change-Id: Ib8cf0d88240ef145da550b8cf83d2580e7140521
Signed-off-by: Szymon Janc <ext.szymon.janc@tieto.com>
In 3 of our UART driver implementations the ISR is exclusively
used and enabled for the RX path. The existing logic was
susceptible to a stall situation where a polled out transmission
would be interrupted by a reception and then the ISR code
would loop forever due to the TX event being signalled (although
the interrupt itself was disabled) causing the ISR to keep
looping for an RX interrupt.
Change-Id: Ic379e58b1c974aca3cee37d2d81f12c3726fb160
Signed-off-by: Carles Cufi <carles.cufi@nordicsemi.no>
The bt_driver API was created when Zephyr only had a Bluetooth host
stack, but no controller-side functionality. The only "driver" that
was needed for the host was the HCI driver, and hence "HCI" was
omitted from the name.
With support both for host and controller Zephyr will be getting more
Bluetooth driver types, in particular radio drivers. To prepare for
this, move all HCI drivers to drivers/bluetooth/hci/ and rename the
bt_driver API bt_hci_driver.
Change-Id: I82829da80aa61f26c2bb2005380f1e88d069ac7d
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>
