For whitelist and resolving list handling, avoid trying to start the
advertiser and scanner roles when they are already running.
Additionally, and since simultaneous scanning and initiating is not
supported, correctly report this to the host both in the supported
states and in the HCI command via an error code, instead of silently
disabling scanning.
Signed-off-by: Carles Cufi <carles.cufi@nordicsemi.no>
Added HAL Radio abstractions to use SoC specific Radio Timings
as documented in SoC's electrical characteristics.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Fixed assert due to incorrect implementation of stopping of
advertiser role under directed advertisement timeout, and
also, fixed assert due to adv stop ticker not being stopped
on advertisement disable from thread mode.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Added checks for advertiser and initiator/target addresses
received in CONNECT_IND when performing directed
advertising.
This is required to pass TP/CON/ADV/BV-04-C [Directed
Advertising Connection].
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
When directed advertisements timed out, connection context
associated was not being released. Subsequent connectable
advertising or connection creation failed.
This is now fixed by releasing the connection context on
directed advertisement timeout.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Refactor whitelist handling into generic filter management in
preparation for future resolving list ID address filters.
Signed-off-by: Carles Cufi <carles.cufi@nordicsemi.no>
This initial commit adds the following:
* Handling of privacy HCI commands
* New Link Layer filter module for both whitelist and resolving list
* Advertising RPA generation with timeouts
Follow-up commits will expand the functionality.
Signed-off-by: Carles Cufi <carles.cufi@nordicsemi.no>
In preparation towards Privacy 1.2, move implementation that
swapped scan response PDU double buffer to same place as
where adv data PDU double buffer is swapped. So that, change
in AdvA in adv data PDU can be reflected in scan response
PDU buffer.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Added a callback function ll_adv_scan_state_cb from the
Controller that gets called on either an advertiser or a
scanner getting started as the Controller's first enabled
state. The callback is also called on the Controller's
last disabled advertising or scanning state.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Fix missing implementation to reset the advertiser state
when directed advertisements stop without a connection being
established.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
As a preparation for advanced filtering (Controller-based privacy) this
commit refactors whitelisting so that it becomes its own module and
actually correctly performs state tracking to avoid modifying the
whitelist when it's in use.
Additionally it also removes the duplicate separate entries for
advertising and scanning, since the specification only allows one single
global whitelist singleton.
Signed-off-by: Carles Cufi <carles.cufi@nordicsemi.no>
Add internal functions to read advertiser and scanner filter
policy if the roles are enabled. This is required to
restrict updates to whitelist and resolving lists when
filter policy are being used by the roles.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Under invalid host behavior, trying to start advertising
while already active would corrupt the advertiser context.
This is fixed by having an explicit flag to check whether
advertiser is already running.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Under invalid host behavior, trying to start scanning while
already active would corrupt the scanner context. This is
fixed by having an explicit flag to check whether scanner is
already running.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Restrict encryption support on nRF51 series SoC to Bluetooth
LE 1M PHY and max. 27 bytes PDU. If 251 bytes PDU using Data
Length Update procedure is desired, then LE Encryption
procedure will not be supported (until a software CCM is
implemented in future).
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Add Kconfig option to be able to conditional compile the
Bluetooth v4.0 LE Encryption procedure.
This is needed in order to be able to not support encryption
on nRF51 series when using Data Length Update procedure with
upto 251 byte payloads until a software-based CCM support is
implemented.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Added extra assert checks to detect controller failure if
a role event preparation function was not followed by the
role event start function.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
In commit c41d3edda when implementing the alternative
encryption setup implementation, the original fast
encryption setup implementation was broken. When host is
slow in responding to LTK request, the controller asserted
when fast encryption implementation is selected. This is
now fixed.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Fix the assert in the controller during connection setup
when peer does not support CSA#2 feature and free Rx buffer
queue does not have enough buffers to generate CSA event.
The assert was reproduced by turning on advertisement
indication and scan request notification features in the
controllers advanced features, and a peer that does not
support CSA#2 initiated a connection.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Added implementation to handle an incoming Reject Ext Ind PDU in
response to a sent Length Req PDU.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
When initiating Data Length Change at the same instant the
crossover condition was not handled correctly causing the
controller to assert.
This fix will allow crossover of Data Length Update
procedure, and this collison is harmless as per Bluetooth
specification, and gracefully handled by the controller.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Since more and more code is going to be reused by both the Host and the
Controller, this commit introduces a common/ folder that will contain
everything that is not tied to one of the two components but shared by
them.
Signed-off-by: Carles Cufi <carles.cufi@nordicsemi.no>
This reverts commit 698de88916 ("Bluetooth: controller:
Cleanup redundant ticker busy loop")
Scan enable asserted in ctrl.c line 3756 due to the fact that a
role event was active and ticker job has hence been disabled.
Add back the busy loop so that scan enable can wait until the
active role event completes gracefully.
The ticker busy loop is mandatory in all ticker interface calls
if a blocking behavior is desired.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
The calculation in packet_rx_reserve_get() was already handled by
packet_rx_acquired_count_get(). So, let's use that code instead
and remove the duplication.
Change-Id: Ic76f70f1e78bebc74f5bef36cd92a3c332e489e9
Signed-off-by: Michael Scott <michael.scott@linaro.org>
This calculation can be used in packet_rx_reserve_get() where currently
the code is duplicated from packet_rx_acquired_count_get().
Let's allow use of packet_rx_acquired_count_get() regardless of whether
CONFIG_BLUETOOTH_CONTROLLER_DATA_LENGTH is enabled.
Change-Id: I613bde0a407f3caccabb22f369098575965e98ad
Signed-off-by: Michael Scott <michael.scott@linaro.org>
During testing, lr->max_rx_octets and lr->max_tx_octets were
at times set to 0. If we use these 0 values, we end up with
very erratic behavior. Best, to check for a sane value and
if invalid, default to the value in _radio.conn_curr->max_*x_octets.
Change-Id: I57c0e3790d988f0de17993cebe5c5c2ab0fc07a6
Signed-off-by: Michael Scott <michael.scott@linaro.org>
Added support for Bluetooth v5.0 PHY Update Procedure in the
Controller.
Asymmetric PHY connections do not work for now due to the
Radio mode not being setup in time in the ISR during tIFS
period and the Radio already ramping up in the cached
previous Radio mode to meet tIFS deadline.
Subsequent commits will add this feature, by either double
buffering the mode in software or using fast radio ramp up
which gives enough time in the ISR to change the mode.
Jira: ZEP-2086
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Scale the ctrl pkt enqueue implementation to allow multiple
ctrl packets to be enqueued. This will aid in the graceful
implementation of parallel control procedure collisions.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Implement the framework for LE Scan Request Received Event.
The feature is available under the Controller's advanced
features and will be selected implcitly when Bluetooth v5.0
LE Advertising Extensions feature is implemented.
Jira: ZEP-2073
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
Introduce alternative TRX switching using dedicated timers
and peripheral interconnect. This will enable the
possibility to independently configure the Tx and Rx
settings between the tIFS.
Note, this will also provide the opportunity to design a
soft realtime Radio ISR.
Signed-off-by: Vinayak Kariappa Chettimada <vich@nordicsemi.no>
In the Controller's radio hal, explicitly differentiate
between Advertisement and Data channel packet
configuration.
Also, remove nRF5x specific extra overhead in Advertisement
PDU structure.
Change-id: I942b88a160af78f8900d7e49fb5f36c8aa493b97
Signed-off-by: Vinayak Chettimada <vinayak.kariappa.chettimada@nordicsemi.no>
The switch from C99 integer types to u16_t, etc. caused misalignment
in structs and function definitions with multi-line parameter lists.
Change-Id: I1448b159ab1afe50ff88b7a6bd1b254c44858d4c
Signed-off-by: Carles Cufi <carles.cufi@nordicsemi.no>
Convert code to use u{8,16,32,64}_t and s{8,16,32,64}_t instead of C99
integer types.
Jira: ZEP-2051
Change-Id: I8f57a17f78e674aca5400f005db8975c9f9e150e
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
This is a start to move away from the C99 {u}int{8,16,32,64}_t types to
Zephyr defined u{8,16,32,64}_t and s{8,16,32,64}_t. This allows Zephyr
to define the sized types in a consistent manor across all the
architectures we support and not conflict with what various compilers
and libc might do with regards to the C99 types.
We introduce <zephyr/types.h> as part of this and have it include
<stdint.h> for now until we transition all the code away from the C99
types.
We go with u{8,16,32,64}_t and s{8,16,32,64}_t as there are some
existing variables defined u8 & u16 as well as to be consistent with
Zephyr naming conventions.
Jira: ZEP-2051
Change-Id: I451fed0623b029d65866622e478225dfab2c0ca8
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
Added support in the Controller for increased feature set
bit fields in Bluetooth 5.0. Cached feature set in the
connection context is increased to a uint32_t value to
accommodate 17 feature bits.
Change-id: I9ae15d6d90fa7a3de186905d3c68088ee22d2911
Signed-off-by: Vinayak Chettimada <vinayak.kariappa.chettimada@nordicsemi.no>
Rename symbol names with channel/chnl to chan.
Change-id: I196ffea79e7e10b0253363949051fdf82be62cb4
Signed-off-by: Vinayak Chettimada <vinayak.kariappa.chettimada@nordicsemi.no>
Use #if defined(...) constructs while using conditional
compilations of advanced event preparation and advanced
scheduling implementations.
Change-id: I728c76d0e7dbbfa378e8978b726ec404d9e55a72
Signed-off-by: Vinayak Chettimada <vinayak.kariappa.chettimada@nordicsemi.no>
Add Controller advanced Kconfig options to select IRQ
priorities of the Radio, Ticker's Worker and JOB IRQs.
This will provide an opportunity to have peripheral IRQ's
of higher level than Bluetooth Controller.
Change-id: Iaa128c1cd64a309a77d42d485fdefe68f31e4895
Signed-off-by: Vinayak Chettimada <vinayak.kariappa.chettimada@nordicsemi.no>
Cleanup redundant ticker busy loop that could hang if the
worker and job IRQ priority levels are misconfigured, and
job gets disabled before all users/mayfly functions using
job complete.
Change-id: I053ad75a4328c51cfe651b820a2fa961e42ae48f
Signed-off-by: Vinayak Chettimada <vinayak.kariappa.chettimada@nordicsemi.no>
Add Kconfig option to enable advanced scheduling in the
controller.
Enable non-overlapping placement of observer, initiator and
master roles in timespace. Uses window offset in connection
updates and uses connection parameter request in slave role
to negotiate non-overlapping placement with active master
roles to avoid slave roles drifting into active master
roles in the local controller.
This feature maximizes the average data transmission amongst
active concurrent master and slave connections while other
observer, initiator, master or slave roles are active in the
local controller.
Disabling this feature will lead to overlapping role in
timespace leading to skipped events amongst active roles.
Change-id: I16e4e6c3ca99f93987ab86924af0cb9d76bdbc7e
Signed-off-by: Vinayak Chettimada <vinayak.kariappa.chettimada@nordicsemi.no>
