This is joint work with Kumar Gala (see signed-off-by).
Document the changes to the generated node macros in macros.bnf,
moving the old file to legacy-macros.bnf and putting it in its own
section.
The actual generated macros are now a low-level detail, so rewrite the
foregoing sections as examples in terms of the new <devicetree.h> APIs.
Signed-off-by: Martí Bolívar <marti.bolivar@nordicsemi.no>
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
The one page on devicetree is too long. Split it into multiple pages
to make it easier to digest and more squintable. This is basically
just moving content around; minimal changes have been made apart from
redoing some transitions and adding a couple of introductory paragraphs.
Rename the 'device-tree' Sphinx :ref: target while we are here.
Signed-off-by: Martí Bolívar <marti.bolivar@nordicsemi.no>
DTSpec writes this as a single word, presumably to make it easier to
grep for / more precise. Follow along in the rest of the docs now that
our main DT docs page agrees with this usage.
Signed-off-by: Marti Bolivar <marti.bolivar@nordicsemi.no>
Overhaul the Bluetooth documentation to split it into manageable units
and include additional information, such as architecture and tooling.
Signed-off-by: Carles Cufi <carles.cufi@nordicsemi.no>
Add cross-referenced information on the 96b_carbon and
96b_carbon_nrf51 pages which disambiguates between the two "boards".
Also describe how to flash 96b_carbon_nrf51 with
samples/bluetooth/hci_spi and 96b_carbon with samples/bluetooth/ipsp
to support a Bluetooth HCI stack on 96Boards Carbon (the physical
board).
While we're here, make the documentation page for 96b_carbon match the
format in doc/templates/board.tmpl.
Signed-off-by: Marti Bolivar <marti.bolivar@linaro.org>
Add a sample application that allows a Zephyr-based Bluetooth
controller to interface with an HCI driver via SPI. This sample
implements the same BT SPI protocol already as Zephyr's HCI SPI
driver.
Currently, the sample only supports the legacy SPI API.
Provide a single configuration file, avoiding board-specific
files. Some board-specific configuration information must be provided
via other means:
- CONFIG_BT_CONTROLLER_TO_HOST_SPI_DEV_NAME
- CONFIG_BT_CONTROLLER_TO_HOST_SPI_IRQ_DEV_NAME
- CONFIG_BT_CONTROLLER_TO_HOST_SPI_IRQ_PIN
Signed-off-by: Ricardo Salveti <ricardo.salveti@linaro.org>
Signed-off-by: Marti Bolivar <marti.bolivar@linaro.org>
Signed-off-by: Michael Scott <michael.scott@linaro.org>