We were hard coding the SPI bus name to "SPI_3". Instead we should use
DT_INVENTEK_ESWIFI_ESWIFI0_BUS_NAME as its generated from the device
tree.
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
The driver was using the straight alias generated defines, however we
want to use DT_ prefixed defines so its clear that the values are coming
from DT.
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
These changes were obtained by running a script created by
Ulf Magnusson <Ulf.Magnusson@nordicsemi.no> for the following
specification:
1. Read the contents of all dts_fixup.h files in Zephyr
2. Check the left-hand side of the #define macros (i.e. the X in
#define X Y)
3. Check if that name is also the name of a Kconfig option
3.a If it is, then do nothing
3.b If it is not, then replace CONFIG_ with DT_ or add DT_ if it
has neither of these two prefixes
4. Replace the use of the changed #define in the code itself
(.c, .h, .ld)
Additionally, some tweaks had to be added to this script to catch some
of the macros used in the code in a parameterized form, e.g.:
- CONFIG_GPIO_STM32_GPIO##__SUFFIX##_BASE_ADDRESS
- CONFIG_UART_##idx##_TX_PIN
- I2C_SBCON_##_num##_BASE_ADDR
and to prevent adding DT_ prefix to the following symbols:
- FLASH_START
- FLASH_SIZE
- SRAM_START
- SRAM_SIZE
- _ROM_ADDR
- _ROM_SIZE
- _RAM_ADDR
- _RAM_SIZE
which are surprisingly also defined in some dts_fixup.h files.
Finally, some manual corrections had to be done as well:
- name##_IRQ -> DT_##name##_IRQ in uart_stm32.c
Signed-off-by: Andrzej Głąbek <andrzej.glabek@nordicsemi.no>
es-WiFi compatible modules use IWIN AT command set.
This driver is split into several layers:
- bus layer: interface to transmit AT commands (SPI, USB, UART...)
- core layer: es-WiFi module management (state, scan...)
- offload layer: TCP/IP offload operations (connect, listen...)
This driver has been tested with stm32l4 disco iot board
(disco_l475_iot1) and the wifi sample:
$ select wifi
$ scan
$ connect "CISCO" 5 password
$ select net
$ tcp connect 192.168.1.21 4242
$ tcp send HelloWorld!
Signed-off-by: Loic Poulain <loic.poulain@linaro.org>
