I personally don't find it very useful to have to maintain prj.conf
and prj_spi.conf for this sample. The information we need to make
this application "just work" with regards to the bus is available in
the devicetree, and Kconfig can now access it using
dt_compat_on_bus().
Do so, enabling I2C and SPI appropriately when a sensor of the right
type is on either of those buses.
If no sensors are enabled, the user gets the build-time error message
in main.c about no devices being found.
This approach is prone to the "stuck symbol" Kconfig problem covered
in our documentation, so a pristine build is necessary to change the
default settings from a previous build.
Signed-off-by: Martí Bolívar <marti.bolivar@nordicsemi.no>
This helps debug issues with the device. Samples should try to be
helpful to first-time users. Send printk() to logging so it doesn't
fight over the UART.
Signed-off-by: Martí Bolívar <marti.bolivar@nordicsemi.no>
Remove generic PRINT macros from sensor samples and replace
with SYS_LOG module.
Jira: ZEP-240
Change-Id: I474efcd1daf8e621acd50d88b3a9662b8cd2b516
Signed-off-by: Juan Manuel Cruz Alcaraz <juan.m.cruz.alcaraz@intel.com>
Remove the CONFIG_SENSOR_DEBUG as it is no longer needed since switching
to SYS_LOG_* in the sensor susbsystem.
Also, use __ASSERT where CONFIG_SENSOR_DEBUG was used to validate
function parameters.
Change-Id: I80ed7209abfb92220fa229d246c5b3a43b887e32
Signed-off-by: Bogdan Davidoaia <bogdan.m.davidoaia@intel.com>
* Rename BMP280 to BME280 which is a superset for the former.
* Autodetect device based on chip ID.
* Implement humidity fetching and reading for BME280
* Rename sample BMP280 to BME280
Change-Id: I565c769a7011e7496c9f1cad861d5ee311839b4f
Signed-off-by: Murtaza Alexandru <alexandru.murtaza@intel.com>
2016-05-17 20:07:34 +00:00
Renamed from samples/sensor/bmp280/prj.conf (Browse further)
