It was too short a file, it was causing duplicate link warnings
(_error_code_conventions, due to the inclusion, which wasn't being
used anyway).
This removes the littering of small files and removes warnings from
the documentation compile.
Change-Id: Ic6f225a63d875d77bd2e93b2712baabea2eb0141
Signed-off-by: Inaky Perez-Gonzalez <inaky.perez-gonzalez@intel.com>
Files that are included directly into other files are not referenced
in TOC trees. Quiet warning by tagging them :orphan:
Change-Id: I3a975420ce366ca155e8c0158dcd0fb7c094a4a0
Signed-off-by: Inaky Perez-Gonzalez <inaky.perez-gonzalez@intel.com>
Add a blank line in most places is the fix needed, to have the
formatting engine recognize it properly.
Change-Id: Iccaa0e51146b1e2c138e89ab1dd0067fc1409e4d
Signed-off-by: Inaky Perez-Gonzalez <inaky.perez-gonzalez@intel.com>
Seem embedding a `code-block` in a `note` section is not working that
well.
Change-Id: I6a0ad0b5a17b2fc1cb9968a85dc794c53a1e27ac
Signed-off-by: Inaky Perez-Gonzalez <inaky.perez-gonzalez@intel.com>
The "IDT Security" section was removed since the IDT is now always
in a read-only region; dynamic IRQs have been deprecated and will
be removed from the kernel.
Change-Id: Idbb7ff987bbb4f777b524d87690485d34f372d43
Signed-off-by: Andrew Boie <andrew.p.boie@intel.com>
D2000 is shipped with no ROM, advise on how to install one.
Change-Id: I848bb0b4fa2d6972cc6919d69a11e14dee0ce50c
Signed-off-by: Inaky Perez-Gonzalez <inaky.perez-gonzalez@intel.com>
The unicode characters for trade mark and register trademark,
although understood by the Atom editor, apparently don't work
here. :-(
Change-Id: Ifbdb25a015630fc90afb18aec6f07a8724fc37f7
Signed-off-by: Chuck Jordan <cjordan@synopsys.com>
Improve this doc to use register trademark and trademark unicode
symbols.
Further, the make rules can benefit from also being passed the argument
ARCH=arc. I see that some zephyr tests use ARCH to select a prj.conf file.
Change-Id: I0650e5d5aba10aa984ebd0be21d0b381dd96dd56
Signed-off-by: Chuck Jordan <cjordan@synopsys.com>
The dependencies for the HCI firmware are now part of the latest
stable MyNewt release, so special editing of project.yml is no longer
needed.
Change-Id: Ia3658ab1da03e208cd5230e0cda4c96a4628e8f0
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>
If you pass arduino_101_factory, it expects a directory with that name,
but really the directory arduino_101 contains the factory config.
Change-Id: I12ce11c0e32a9d50998b52c2e2c16780b6ce00da
Signed-off-by: Geoff Gustafson <geoff@linux.intel.com>
Tinycrypt is maintained at github and thus should be treated as an
external library and hosted under ext/.
Change-Id: I4c4a3bcdacf01d4922919e5ea1f9dec21a19cd37
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
Marketing is telling me to switch URLs for the EM Starter Kit
board story.
Change-Id: I342849d1085330eb9e5e88f08374bb5889695702
Signed-off-by: Chuck Jordan <cjordan@synopsys.com>
Correct the indentation of numbered lists to
appear correctly once render.
Change-Id: Ie1b92a7c5d2517e4f36626858404458c3b461be9
Signed-off-by: Carles Cufi <carles.cufi@nordicsemi.no>
Generate kernel image in Intel Hex format when building for the nRF52.
Remove the additional step from the board doc file.
Change-Id: I619496f64037c2a0ac459ae05e549e01458e0f71
Signed-off-by: Carles Cufi <carles.cufi@nordicsemi.no>
Few lines in the doc were out of sync with the code base.
Jira: ZEP-312
Change-Id: Ic0d3508f0f903e43000e17b4a32c1280ae0978dc
Signed-off-by: Jithu Joseph <jithu.joseph@intel.com>
Board support for the ARC EM Starter Kit provides for a board
that can select one of two SOCs. The EM9D and EM11D commits
will be done separately to expidite review. Also submitted here
is doc/board/em_starterkit.rst to explain details about this
Zephyr board choice.
Change-Id: Icd9fac045c700ad8dcb95161fdd63c130f665778
Signed-off-by: Chuck Jordan <cjordan@synopsys.com>
By default, kernel event logger is using the system timer. But on
some platforms where the timer driver maintains the system timer
cycle accumulator in software, such as ones using the LOAPIC timer,
the system timer behavior leads to timestamp errors. For example,
the timer interrupt is logged with a wrong timestamp since the HW
timer value has been reset (periodic mode) but accumulated value not
updated yet (done later in the ISR).
This patch is adding the possibility to register a timer callback
function that will be used by the kernel event logger. For example,
on Quark SE, this allows using RTC or AON counter which accuracy is
sufficient and behavior more straight forward compared to system
timer.
Change-Id: I754c7557350ef29fc10701e62a35a5425e035f11
Signed-off-by: Fabrice Olivero <fabrice.olivero@intel.com>
Fix a few small (mainly rendering) issues with the arduino_101.rst
document:
- A few paragraphs had the wrong indentation
- A sub-list did not appear as such (serial port settings)
- Remove the 'Bibliography' section which appears empty
- Fix IO-3 and IO-5 pin names in note
Change-Id: I60ad839de1901167b6793254186836015502aaab
Signed-off-by: Geoffroy Van Cutsem <geoffroy.vancutsem@intel.com>
Document the process of creating and flashing a MyNewt-based HCI
firmware for the Arduino 101.
Change-Id: Ieb3cf116363777b8cca20dbcc746e4757f47d2ed
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>
The Arduino 101 board in Zephyr now support the original bootloader
and thus supports flashing over DFU. Adapt documentation and remove
reference to alternate bootloader which has been causing issues
and does not support flashing of the bluetooth firmware.
Jira: ZEP-301
Change-Id: I0298d8938bb636319b213909594d8cb42417559a
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
Added CONFIG_KERNEL_EVENT_PROFILER_DYNAMIC flag for enabling that
capability. When set, nothing will be logged by default
Change-Id: I03552483e5a6bfd9e2505eda56908f0d0ae98618
Signed-off-by: Fabrice Olivero <fabrice.olivero@intel.com>
OS tick period (usually 10 ms) is not sufficiently precise for task
execution analysis (like processing CPU load per context)
With that modification, the timestamp used by the kernel event logger
is 32-bit LSB of platform HW timer (for example Lakemont APIC timer
for Quark SE).
This timer period is very small and leads to timestamp wraparound
happening quite often (e.g. every 134s for Quark SE).
This wraparound must be considered when analyzing kernel event logger
data and care must be taken when tickless idle is enabled and sleep
duration can exceed maximum HW timer value.
Change-Id: Idc545da8f828a7357a69d83ff25c9afd09dab3c4
Signed-off-by: Fabrice Olivero <fabrice.olivero@intel.com>
Do not use a TOC, instead put all options in a table and use references.
Jira: ZEP-149
Change-Id: I23821759c64ce28241ee8260ad7cba235df72d86
Signed-off-by: Anas Nashif <anas.nashif@intel.com>
The fixed link was broken when development documentation started being
hosted at /doc instead of /doc/dev
Change-Id: I3621bf83beb030e7d80f60e1d148cd7311d25cdf
Signed-off-by: Genaro Saucedo Tejada <genaro.saucedo.tejada@intel.com>
Edited and added minor markup for consistancy.
Edited some '/' to clarify 'and' 'or'.
Change-Id: I5aa84f278d65e79d12b634fcbef2a8b5070c8ebd
Signed-off-by: Gerardo Aceves <gerardo.aceves@intel.com>
Jira: ZEP-177
Changes the documentation for the toolchain path. Some windows environments
need the ISSM installation path to be written in windows format.
Change-Id: Ib4729eb668e0daa7f7f520f208def4be6b86c692
Signed-off-by: Juan Manuel Cruz <juan.m.cruz.alcaraz@intel.com>
