In some cases the net_pkt can be null when freeing it,
this will print error from net_pkt library. Avoid this by
checking the value of net_pkt before calling net_pkt_unref().
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
If we re-connect to same peer server, then we should select a new
source port. Noticed that if the same source port as before is
used for the new connection, the peer might drop the packet. This
was seen when connecting to Linux peer.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
Defines a new tunable, CONFIG_NET_TCP_RETRY_COUNT, that determines the
number of segment retransmissions that the IP stack will attempt to
perform before resetting the connection.
The default value is 9 retransmissions, which amounts to 1:42 minutes,
as close as possible to the minimum recommended by RFC1122.
Jira: ZEP-1956, ZEP-1957
Signed-off-by: Leandro Pereira <leandro.pereira@intel.com>
If we receive unknown option in neighbor advertisement message,
then skip those properly. Old code did not check the length of
the extension options which could cause infinite loop.
Jira: ZEP-2219
Signed-off-by: Ruslan Mstoi <ruslan.mstoi@intel.com>
If we received a bad HTTP request, then subsequent good requests
were also returning 400 error code. The parsing state needs to
be initialized after each received HTTP request.
Jira: ZEP-2181
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
Fixes the following issue:
"In expression 1UL << chan - 1U, left shifting by more than 31
bits has undefined behavior. The shift amount, chan - 1U, is
4294967295."
Coverity-CID: 167140
Jira: ZEP-2131
Signed-off-by: Leandro Pereira <leandro.pereira@intel.com>
Print also network buffers that are allocated by the IPv6
fragment handler. This is very useful in debugging.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
If the user really wants, it is possible to increase the
maximum size of the fragmented packet. According to RFC 2460
chapter 5, we do not need to accept larger than 1500 byte IPv6
packets, so the max pkt limit is set to 2. But if really needed
the limit can be raised by defining NET_IPV6_FRAGMENTS_MAX_PKT
to some new value. Currently there is no Kconfig option for
doing this as it is unlikely that this is needed.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
The cancellation of reassembly did not work as expected because
K_WORK_INITIALIZER() did not setup the timeout function properly.
So do the timer initialization at runtime instead.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
The IPv6 fragmentation was not working properly when the large
IPv6 packet was being sent. There is unit tests in next commit
that will test the IPv6 fragmentation sending.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
If the fragmented IPv6 packet was very large, we could run out
of resources. When that happened, we leaked the memory for the
pending fragments that were waiting reassembly.
Jira: ZEP-2166
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
The previous default 60 seconds is way too long for our limited
amount of memory. It might be that the 5 sec is still too long
but that can be changed in the future.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
Shell itself already have a help command, so instead of creating a net
specific help just fill the help description of each command.
Signed-off-by: Luiz Augusto von Dentz <luiz.von.dentz@intel.com>
Shell modules are registered at link time thus it makes no sense to
leave it behind net_shell_init.
Signed-off-by: Luiz Augusto von Dentz <luiz.von.dentz@intel.com>
If the HTTPS connection is closed, then properly handle call to
HTTP parser init in case of error and also remove any pending
data that belong to old connection.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
If we receive unknown option in neighbor solicitation message,
then skip those properly. Old code did not check the length of
the extension options which could cause infinite loop.
Jira: ZEP-2174
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
If we could not split the packet properly, make sure that the
fragments that we managed to allocate are unreffed and marked
as NULL.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
Print also the character when hexdumping a memory area.
This is useful so that one does not need to convert hex
values to characters in head. Unprintable chars are printed
as '.'
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
No need to check attr and path variables for null as they
cannot be null.
Coverity-CID: 157595
Coverity-CID: 157602
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
Allow the caller to delay the closing of the HTTP connection
for a number of milliseconds. The purpose for this is that
the client can send still some data back to us for a short
period of time.
This is needed for example for Basic authentication so that
server is able to receive authentication values back.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
The address family of the UDP port listener was not set. This
caused weird debug prints in net-shell. Now the listener will
be registering IPv4 any address as it should.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
When a connection handler was registered, the checker function
introduced in commit 43b37cef ("Check duplicate UDP/TCP connection
handlers") did not check the address family (IPv4 or IPv6) of
the local end point properly. This caused duplicate connection
error to be returned to the caller.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
The uncompressed source address in packets was not handled properly if
NET_6LO_CONTEXT was enabled.
This implementation is identical to the contextless case.
Signed-off-by: Piotr Zierhoffer <pzierhoffer@antmicro.com>
If we do not receive last ACK when the connection is tore down,
then do not wait forever as that would eat all the resources in
the network stack. So when we enter the LAST_ACK state, we setup
a timer that will unref the connection if the last ACK is not
received.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
Without change to add ACK to FIN, invalid TCP packet is generated,
where ack sequence number is non-zero. Without adjusting sequence
number as done, ACK which we send in response to peer's FIN/ACK is
not recognized by peer, and peer keeps retransmitting its FIN/ACK.
Jira: ZEP-2104
Signed-off-by: Paul Sokolovsky <paul.sokolovsky@linaro.org>
When connection handler was unregistered, we did not remove
it from cache. This caused invalid connection to be passed to
net_context after connection unregister if connection caching
was enabled.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
We did not check UDP or TCP checksum to be valid after receiving
the packet. Fix this so that the checksum is validated when
packet is received in connection handler. As the checksum validation
can be resource intensive, do it after we have verified that
there is a connection handler for this connection.
The checksum calculation can be turned OFF if needed, but it is
ON by default.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
The commit "net: tcp: Handle retransmitted packets from peer"
introduced over 80 character line that was missed in review.
Fixing it now.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
If user has enabled RPL and STATISTICS, then enable RPL
statistics by default as that is probably what user want.
Same thing for MLD statistics.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
When we receive a packet with the sequence we already seen (and
processed), the most likely cause of it is that our ACK was lost,
and peer has to retransmit that packet. Then, we should just ACK
it, because otherwise peer will retransmit it again and again,
falling into exponential backoff and hosing the entire TCP
connection.
This makes changes to send_ack(), adding a flag to force sending
an ACK regardless of its cached status, and remove inline modifier,
as the function is big and called from many places.
Signed-off-by: Paul Sokolovsky <paul.sokolovsky@linaro.org>
We must check if we receive RST in any of the TCP states.
If we do not do this, then the net_context might leak as it
would never be released in some of the states. Receiving RST
in any TCP state is not described in TCP state diagram but is
described in RFC 793 which says in chapter "Reset Processing"
that system "...aborts the connection and advises the user and
goes to the CLOSED state."
We need to also validate the received RST and accept only those
TCP reset packets that contain valid sequence number.
The validate_state_transitions() function is also changed to
accept CLOSED state transition from various other states.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
net_if_get_default() was documented as returning "Default interface
or NULL if no interfaces are configured.", but actually didn't
return NULL in the latter case. Instead, it effectively returned
a pointer to random area of memory, shared with other system
structures, so calling functions like net_if_ipv4_set_netmask(),
etc. could trash unrelated memory.
Jira: ZEP-2105
Signed-off-by: Paul Sokolovsky <paul.sokolovsky@linaro.org>
RFC793, "Transmission Control Protocol", defines sequence numbers
just as 32-bit numbers without a sign. It doesn't specify any adhoc
rules for comparing them, so standard modular arithmetic should be
used.
Signed-off-by: Paul Sokolovsky <paul.sokolovsky@linaro.org>
This commit creates a HTTP server library. So instead of creating
a complex HTTP server application for serving HTTP requests, the
developer can use the HTTP server API to create HTTP server
insteances. This commit also adds support for creating HTTPS servers.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
When a new UDP or TCP connection handler is to be registered,
we need to check if identical handler has already been created.
If a duplicate is found, the registering call will return -EALREADY.
The earlier code did not check this but allowed two identical
handlers to be created. The latter handler was never called in
this case.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
This helper copies desired amount of data from network packet
buffer info a user provided linear buffer.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
When we send TCP data segment, we need to set the length
of the application data by calling net_pkt_set_appdatalen().
This is done so that sequence number can be properly
advanced when we receive ACK to that pending packet.
Signed-off-by: xiaorui hu <xiaorui.hu@linaro.org>
fix misspelling in Kconfig files that would show up in configuration
documentation and screens.
Signed-off-by: David B. Kinder <david.b.kinder@intel.com>
Instead of separate sample application that does everything
related to HTTP client connectivity, create a HTTP client library
that hides nasty details that are related to sending HTTP methods.
After this the sample HTTP client application is very simple and
only shows how to use the client HTTP API.
Signed-off-by: Jukka Rissanen <jukka.rissanen@linux.intel.com>
