* Utilize DT_HAS_<COMPAT>_ENABLED for devicetree based drivers
* Move to using select I2C' instead of 'depends on'
(see commit df81fef944 for
more details)
Signed-off-by: Kumar Gala <galak@kernel.org>
Use this short header style in all Kconfig files:
# <description>
# <copyright>
# <license>
...
Also change all <description>s from
# Kconfig[.extension] - Foo-related options
to just
# Foo-related options
It's clear enough that it's about Kconfig.
The <description> cleanup was done with this command, along with some
manual cleanup (big letter at the start, etc.)
git ls-files '*Kconfig*' | \
xargs sed -i -E '1 s/#\s*Kconfig[\w.-]*\s*-\s*/# /'
Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no>
Defining a symbol with 'menuconfig' just tells the menuconfig to display
any dependent symbols that immediately follow it in a separate menu.
'menuconfig' has no effect on symbol values.
Making a symbol that doesn't have any dependent symbols after it a
'menuconfig' should be avoided, because then you end up with an empty
menu, which is shown as e.g.
[*] Enable foo ---
This is how it would be shown if there were children but they all
happened to be invisible as well.
With a regular 'config', it turns into
[*] Enable foo
Change all pointless 'menuconfig's to 'config's.
See the section on 'menuconfig' on the Kconfig - Tips and Best Practices
page as well.
Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no>
Every board that uses dts-enabled i2c drivers has a board-level dts, so
there is no need to have separate configs HAS_DTS_I2C_DEVICE and
HAS_DTS_I2C.
Signed-off-by: Maureen Helm <maureen.helm@nxp.com>
- Remove redundant 'n' defaults. 'n' is the default value for bool
symbols.
This makes the auto-generated documentation clearer as well: You get
"implicitly defaults to n" instead of
"- n if <propagated dependencies>".
- Shorten
<type>
prompt "foo"
to
<type> "foo"
This works for all types, not just bool.
- Various formatting nits.
Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no>
Add support for NXP PCA9633 an I2C 4-bit LED driver.
Supported blinkink period: 41ms to 10667ms
Supported brightness value: 0 to 100%
This driver supports the following APIs:
1. led_blink
2. led_set_brightness
3. led_on
4. led_off
Signed-off-by: Sebastien Bourdelin <sebastien.bourdelin@savoirfairelinux.com>
