Replace the manually implemented GPIO-based I2C recovery logic
with Zephyr's i2c_bitbang API.
Signed-off-by: Tim Lin <tim2.lin@ite.corp-partner.google.com>
Sometimes, channel C may write wrong register to the target device.
This issue occurs when FIFO2 is enabled on channel C. The problem
arises because FIFO2 is shared between channel B and channel C.
FIFO2 will be disabled when data access is completed, at which point
FIFO2 is set to the default configuration for channel B.
The byte counter of FIFO2 may be affected by channel B. There is a
chance that channel C may encounter wrong register being written due
to the FIFO2 byte counter wrong write after channel B's write operation.
The current workaround is that channel C cannot use FIFO mode.
Signed-off-by: Tim Lin <tim2.lin@ite.corp-partner.google.com>
Add I2C target driver used buffer mode. The maximum accessible buffer
is 2044 bytes, the default is 256 bytes.
Signed-off-by: Tim Lin <tim2.lin@ite.corp-partner.google.com>
Adding I2C FIFO mode can reduce the time between each byte to
improve the I2C bus clock stretching during I2C transaction.
The I2C master supports two 32-bytes FIFOs, channel A and C
are supported now.
I2C FIFO mode of it8xxx2 can support I2C APIs including:
i2c_write(), i2c_read(), i2c_burst_read.
Test:
1. tests\drivers\i2c\i2c_api --> pass
2. Reading 16 bytes of data through i2c_burst_read() can reduce
0.52ms(2.4ms->1.88ms) compared to the original pio mode when the
frequency is 100KHz.
3. It is normal to read sensor data through I2C on Nereid's platform.
Signed-off-by: Tim Lin <tim2.lin@ite.corp-partner.google.com>
Update i2c drivers to use DT_HAS_<compat>_ENABLED Kconfig symbol
to expose the driver and enable it by default based on devicetree.
We remove 'depend on' Kconfig for symbols that would be implied by
the devicetree node existing.
Signed-off-by: Kumar Gala <galak@kernel.org>
Adding command queue mode can reduce the time between each byte to
improve the I2C bus clock stretching during I2C transaction.
I2C command queue mode of it8xxx2 can support I2C APIs including:
i2c_write(), i2c_read(), i2c_burst_read.
Test:
1. tests\drivers\i2c\i2c_api --> pass
2. Reading 16 bytes of data through i2c_burst_read() can reduce
0.72ms(2.54ms->1.82ms) compared to the original pio mode when the
frequency is 100KHz.
3. krabby platform can boot normally.
Signed-off-by: Tim Lin <tim2.lin@ite.corp-partner.google.com>
As mentioned in #42882, the I2C of IT8XXX2 is designed for two different
IP blocks, so this PR divides this I2C driver into two compatibles.
Signed-off-by: Tim Lin <tim2.lin@ite.corp-partner.google.com>
Add some simple depends so we limit various I2C drivers to the SoC
families that the drivers are relevant to.
Signed-off-by: Kumar Gala <kumar.gala@linaro.org>
This commit is about the it8xxx2 i2c master driver which
includes six SMBus channels. The enhanced channel i2c3,
i2c4, i2c5 are controller which are designed to support
the I2C protocol.
Signed-off-by: Tim Lin <tim2.lin@ite.corp-partner.google.com>
