For DA1469x if PM config is selected PM_DEVICE must also
be selected for GPIO to work when device enters/exists
deep sleep.
Previously GPIO and regulator drivers selected PM_DEVICE
when PM was enabled.
Now it is moved to SOC instead.
PM_DEVICE selection in GPIO could result in circular dependency
for mcux if MEMC_MCUX_FLEXSPI (which is already dependent on PM_DEVICE)
was to be additionally dependent on GPIO.
Signed-off-by: Jerzy Kasenberg <jerzy.kasenberg@codecoup.pl>
This adds automatic GPIO latching before going to extended sleep and
restoring state after wakeup.
Mode and state for each pin is stored, then ports are latched to retain
state when PD_COM is disabled during sleep. On wakeup mode and state for
each pin is restored and ports are unlatched to make it work again.
Signed-off-by: Andrzej Kaczmarek <andrzej.kaczmarek@codecoup.pl>
Signed-off-by: Jerzy Kasenberg <jerzy.kasenberg@codecoup.pl>
This adds GPIO driver for Renesas SmartBond(tm) family.
Driver supports pin configuration (input/output) and interrupts on edge.
Interrupts on level are not supported by hardware.
Signed-off-by: Andrzej Kaczmarek <andrzej.kaczmarek@codecoup.pl>
Signed-off-by: Ben Lauret <ben.lauret.wm@renesas.com>
