* Utilize DT_HAS_<COMPAT>_ENABLED for devicetree based drivers
* Move to using 'select SPI' instead of 'depends on'
(see commit df81fef944 for
more details)
Signed-off-by: Kumar Gala <galak@kernel.org>
According to Kconfig guidelines, boolean prompts must not start with
"Enable...". The following command has been used to automate the changes
in this patch:
sed -i "s/bool \"[Ee]nables\? \(\w\)/bool \"\U\1/g" **/Kconfig*
Signed-off-by: Gerard Marull-Paretas <gerard.marull@nordicsemi.no>
How prompts work is better documented nowadays, and these comments might
not be that helpful if you don't know.
There are lots promptless symbols that don't have a comment.
Also fix up some comments in arch/Kconfig that seem misplaced/redundant,
and clean up some whitespace (no blank line after a comment makes it
look like it only applies to the symbol directly after it to me).
Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no>
Use this short header style in all Kconfig files:
# <description>
# <copyright>
# <license>
...
Also change all <description>s from
# Kconfig[.extension] - Foo-related options
to just
# Foo-related options
It's clear enough that it's about Kconfig.
The <description> cleanup was done with this command, along with some
manual cleanup (big letter at the start, etc.)
git ls-files '*Kconfig*' | \
xargs sed -i -E '1 s/#\s*Kconfig[\w.-]*\s*-\s*/# /'
Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no>
When used suitable config overlay, qemu_cortex_m3 with Ethernet
support can be started with just usual "make run".
An example of such overlay is included with samples/net/echo_server,
can be built and run with:
make BOARD=qemu_cortex_m3 \
CONF_FILE="prj.conf overlay-qemu_cortex_m3_eth.conf" run
Signed-off-by: Paul Sokolovsky <paul.sokolovsky@linaro.org>
The driver can be tested using different networking emulation
approaches.
This approach will work across multiple Qemu instances. There can be
more than one Qemu instance, run using the following command. They
would appear to be on the same Ethernet network.
$ qemu-system-arm -M lm3s6965evb \
-serial stdio \
-net nic \
-net socket,mcast=230.0.0.1:1234 \
-kernel zephyr.elf
This approach will work with other virtualization technologies that
support connecting to a VDE switch, like VirtualBox and User Mode
Linux. The switch can be started using the following command.
$ vde_switch --sock /tmp/switch
Qemu can be connected to the switch using the following command.
$ qemu-system-arm -M lm3s6965evb \
-serial stdio \
-net nic \
-net vde,sock=/tmp/switch \
-kernel zephyr.elf
Signed-off-by: Fadhel Habeeb <fadhel@zilogic.com>
Signed-off-by: Nirav Parmar <niravparmar@zilogic.com>
Signed-off-by: Vijay Kumar B <vijaykumar@zilogic.com>
