In case of dualcore, STM32H7, STM32W and STM32MP1,
protect concurrent register write access with HSEM.
Done for following drivers:
clock_control, counter, flash, gpio, interrupt_controller
Signed-off-by: Alexandre Bourdiol <alexandre.bourdiol@st.com>
On cortex M4, AHB clock is equal to SystemCoreClock
On Cortex M7, AHB clock is equal to SystemCoreClock/HPRE
By the way, D1CPRE is of no use when starting from SystemCoreColck.
Signed-off-by: Alexandre Bourdiol <alexandre.bourdiol@st.com>
Move PWR init code out of clock control driver and
put SMPS related function under SMPS condition as it
is not supported by all soc variants of the series.
Fixes#22363
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
The build infrastructure should not be adding the drivers subdirectory
to the include path. Fix the legacy uses that depended on that
addition.
Signed-off-by: Peter Bigot <peter.bigot@nordicsemi.no>
The build infrastructure should not be adding the drivers subdirectory
to the include path. Fix the legacy uses that depended on that
addition.
Signed-off-by: Peter Bigot <peter.bigot@nordicsemi.no>
STM32 clock control subsystem allows to configure a different
frequency value for core clock (SYSCLK) and AHB clock (HCLK).
Though, it is HCLK which is used to feed Cortex Systick timer
which is used in zephyr as reference system clock.
If HCLK frequency is configured to a different value from SYSCLK
frequency, whole system is exposed to desynchro between zephyr clock
subsytem and STM32 HW configuration.
To prevent this, and until zephyr clock subsystem is changed to be
aware of this potential configuration, enforce AHB prescaler value
to 1 (which is current default value in use for all STM32 based
boards).
On STM32H7, enforce D1CPRE which fills the same role as ABH precaler.
On STM32MP1, the equivalent setting is done on A7 core, so it is
not exposed to the same issue as long as SYS_CLOCK_HW_CYCLES_PER_SEC
is set with the 'mlhclk_ck' clock frequency value. Update
matching boards documentation.
Fixes#17188
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
On STM32H7, in Dual core configuration, we restrict configuration
access to CM7 core. CM4 can access to API but not the init part of
the driver.
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
Provide basic clock control driver for STM32H7.
Bus clock activation is done through CM7 and CM4 common registers
so we don't have to care to the CPU Id before accessing.
Accesses are not protected for now. Only possible configuration
is system clock source set to HSE driven PLL.
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
