For tests that set CONFIG_MP_NUM_CPUS, switch to using
CONFIG_MP_MAX_NUM_CPUS instead as we work to phase out
CONFIG_MP_NUM_CPUS.
Signed-off-by: Kumar Gala <kumar.gala@intel.com>
Disabling SMP mode for certain tests was a one-release thing, done to
avoid having to triage every test independently (MANY are not
SMP-safe), and with the knowledge that it was probably hiding bugs in
the kernel.
Turn it on pervasively. Tests are treated with a combination of
flagging specific cases as "1cpu" where we have short-running tests
that can be independently run in an otherwise SMP environment, and via
setting CONFIG_MP_NUM_CPUS=1 where that's not possible (which still
runs the full SMP kernel config, but with only one CPU available).
Signed-off-by: Andy Ross <andrew.j.ross@intel.com>
(Chunk 1 of 3 - this patch was split across pull requests to address
CI build time limitations)
Zephyr has always been a uniprocessor system, and its kernel tests are
rife with assumptions and outright dependence on single-CPU operation
(for example: "low priority threads will never run until this high
priority thread blocks" -- not true if there's another processor to
run it!)
About 1/3 of our tests fail right now on x86_64 when dual processor
operation is made default. Most of those can probably be recovered on
a case-by-case basis with simple changes (and a few of them might
represent real bugs in SMP!), but for now let's make sure the full
test suite passes by turning the second CPU off. There's still plenty
of SMP coverage in the remaining cases.
Signed-off-by: Andy Ross <andrew.j.ross@intel.com>
The intent of this Kconfig is to allow libc stdout
functions like printf() to send their output to the
active console driver instead of discarding it.
This somehow evolved into preferring to use
printf() instead of printk() for all test case output
if enabled. Libc printf() implementation for both
minimal libc and newlib use considerably more stack
space than printk(), with nothing gained by using
them.
Remove all instances where we are conditionally
sending test case output based on this config, enable
it by default, and adjust a few tests that disabled
this because they were blowing stack.
printk() and vprintk() now work as expected for
unit_testing targets, they are just wrappers for
host printf().
Fixes: #13701
Signed-off-by: Andrew Boie <andrew.p.boie@intel.com>
Add a test to verify that k_sleep() can be used to put
the calling thread to sleep for a specified number of
ticks during system initialization.
This test is inspired from legacy test_early_sleep test
from v1.7.0 release.
Signed-off-by: Ramakrishna Pallala <ramakrishna.pallala@intel.com>
