Rename all Silicon Labs dev kits to always use the official kit name
as board target name. Previous kit names used various naming schemes,
including putting part of the SoC name in the board name. With HWMv2,
SoC names (if needed) should go in the SoC board qualifier.
Use HWMv2 revisions for the two variants of SLTB010A.
Split the xG27 Dev Kit from the EFR32BG22 Thunderboard. This attempt
at deduplication is confusing due to the very different kit names
and use of different ICs (BG22 vs BG27), and was not continued with
the xG24 Dev Kit, meaning that it wasn't consistent.
Signed-off-by: Aksel Skauge Mellbye <aksel.mellbye@silabs.com>
Sensor Kconfig sybmols should be enabled if CONFIG_SENSOR=y
and the devicetree node for the sensor is enabled. We can
remove explicitly enabling specific sensor drivers in .conf
files.
Signed-off-by: Kumar Gala <galak@kernel.org>
These changes turn out to have been incompatible with the way pinctrl
drivers are going to work, so we need to go back to what we had before
until we can agree on a better approach.
Squash of the following reverts:
Revert "boards: nrf: fix deprecated I2C properties"
This reverts commit 2a4ac9ac02.
Revert "samples: switch nrf overlays to sda-gpios, scl-gpios"
This reverts commit 01bb08e7d8.
Revert "boards: nrf: switch to sda-gpios, scl-gpios"
This reverts commit 17a66304c4.
Revert "i2c: nordic: switch to phandle arrays for pinmux"
This reverts commit 821c03a14a.
Signed-off-by: Martí Bolívar <marti.bolivar@nordicsemi.no>
I only see one sample with an overlay using the now legacy sda-pin and
scl-pin properties. Move it to the new style.
Signed-off-by: Martí Bolívar <marti.bolivar@nordicsemi.no>
Update devicetree sources and bindings, switch to new GPIO API. Use
devicetree property name to identify interrupt signal.
Signed-off-by: Peter Bigot <peter.bigot@nordicsemi.no>
