There were wrong GPIOs assigned for antenna switches.
Used pins were assigned to other peripehrals so that
there were no outpus printed.
The samples should use GPIOs that are not assigned to any
peripheral.
Signed-off-by: Piotr Pryga <piotr.pryga@nordicsemi.no>
To give control over GPIO pins for Direction Finding Extension of
Radio peripheral when build for nRF53 network core, the application
core has to assign those pins to network core.
There is a mechanism that uses a device tree overlay to get
information about GPIO pins to be assigned to network core.
The commit adds overlays with appropriate configuration
to assign GPIO pins in all DF related samples.
Signed-off-by: Piotr Pryga <piotr.pryga@nordicsemi.no>
To give control over GPIO pins for Direction Finding Extension of
Radio peripheral when build for nRF53 network core, the application
core has to assign those pins to network core.
There is a mechanism that uses a device tree overlay to get
information about GPIO pins to be assigned to network core.
The commit adds overlays with appropriate configuration
to assign GPIO pins in all DF related samples.
Signed-off-by: Piotr Pryga <piotr.pryga@nordicsemi.no>
Since periodic advertising chains are available there is
a possibility to send multiple PDUs including CTE in
a periodic advertising event.
This commit enables such functionality in direction finding
transmitter sample.
Signed-off-by: Piotr Pryga <piotr.pryga@nordicsemi.no>
Move configuration related with BLE controller into board specific file.
That is required to allow building the sample for nRF5340 where BLE
controller is not part of the sample image.
Signed-off-by: Piotr Pryga <piotr.pryga@nordicsemi.no>
Add an application that uses Direction Finding API for
transmission of CTE in connectionless mode (periodic adverising PDUs).
Signed-off-by: Piotr Pryga <piotr.pryga@nordicsemi.no>
